Want this question answered?
The drive gear is broken in the window motor. Remove motor and install gear kit.
How do I remove the heatrest off of a 2000 LT Chevrolet Silverado
Completely remove the inside door panel. Since the window is down, the two screws that hold the window glass to the regulator should be easily acessable. Remove these two screws. Disconnect the regulator from the window glass. Push the window glass up to the very top. A bungy cord can be used to hold the glass up while the motor is being removed. Hook the bungy cord to the top of the door. Hook the other end to the bottom of the window glass.
The window sash clips connect the door glass to the regulator. The part # for the 2000-2004 is 22689012. Once the glass is out You can heat and remove the old sash and epoxy the new ones in place!
what u need to do is first remove the door trim then remove the water shield. remove the inner belt weatherstrip but be careful. it will rip easily. roll the window down to gain access to the glass attachment fasteners then remove the 2 bolts holding the regulator lift channel to the door glass then lift the glass out and your done...
The relays are integrated into the switch itself.
Go to autozone.com and sign up then go to the repair tips section and print what you need. answer remove inside door lining u will need window up remove bolts that hold window moter in door put hand inside door and remove to rplace just work backwards from removing
Remove the rear door panel.
There are guides that clip on the glass, one is on the upper rear of the glass,and the is on the lower front. Most of the time the one on the rear breaks causing the window glass to tip forward. You can remove the old clip & install the new while the glass is out of the track.And then reinstall the window by seating it back in the channel.
How do you remove and replace the motor for the drivers side power window in a 2000 Sienna
This might get you started... http://www.2carpros.com/how_to/power_window.htm
You will have to replace the complete window regulator assembly.