answersLogoWhite
Chevy Silverado
Chevy Tahoe
Ford Expedition Eddie Bauer
Ford Expedition XLT

How do you remove driver side door panel on a 1997 1500 with power windows?


Top Answer
User Avatar
Wiki User
2006-08-15 21:30:57
2006-08-15 21:30:57

Take all screws that you can see from the panel, once you see you have all screws out start at the bottom ang gently just pull out it will pop off, the plastic plugs will be a little hard to pull out but they will come then be gentle and look under the panel and unplug the wires from the switch panel and its off, put it back on the same way, just allign the plastic plugs with the holes in the door and hit with your hand or rubber hammer the will pop back in place, then put the screws in, and you're done.

Related Questions

User Avatar

are they wind up windows or power windows? for power windows remove the door panel screws and pull. for wind up windows remove small metal snap rings behind the window handle. remove them and then remove all door panel screws and pull door panel off.

User Avatar

* On models with power door locks and/or power windows disconnect the negative battery cable.If equipped with Delco Loc 2 or Theftlock audio system make sure you have the activation code * On models with power door locks pry the power door lock switch out of the door trim panel with a flat-blade screwdriver unplug the electrical connector from the switch and remove the switch * On models with power windows pry the power window switch out of the trim panel with a flat-blade screwdriver unplug the electrical connector from the switch and remove the switch * On models with manually-operated windows remove the window regulator handle * Remove the trim panel screws * Once all of the screws are removed detach the trim panel from the door disconnect any electrical connectors and remove the trim panel from the vehicle by lifting it up and away from the door

User Avatar

You need to remove the arm rest, and the power lock switche,and the mirror control. pop all the panel clips on the edge of the door panel with a scew driver. Than with the window down, lift up on the panel .

User Avatar

Remove switch panel and jump wires on switch- if this works bad switch Remove door panel and see if the motor is getting power-if it is getting power, bad motor

User Avatar

You need to remove the window hand crank with a window hand crank removal tool.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.