0
How do you remove fan from 1993 ford econoline e150 4.9liter 6 cylinder?
Wiki User
∙ 13y ago
You need to rent or buy a fan clutch removal tool kit. you need to remove the fan and clutch as one before you can separate the fan from the clutch.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
What tools do you need to remove the wheel cylinder on a 1993 Pontiac Bonneville?
what tools do i need to remove the wheel cylinder on a 1993 pontiac bonneville
Diagram of a fuse box in a 1993 ford econoline van?
Is there a third fuse box for my 1993 ford econoline van for the rear heater
How many tons does a 1993 ford econoline van with a 5.8 engine weigh?
about how many tons does a 1993 for econoline van with a 5.8 engine weigh?
How do you remove a 1993 Ford Mustang transmission?
can anyone tell me how to remove a transmission from a 1993 ford mustang 4 cylinder? Thanks sailtome69@yahoo.com
How many tons does a 1993 Ford Econoline van weigh?
A 1993 Ford E-150 XL Econoline van weighs 4470 lbs. (over two tons).
How do you remove the trunk lock cylinder from a 1993 lebaron GTC convertible?
Show removel of trunk lock 1993 chrysler lebaron
What size transmission will fit a 1993 Ford E350 econoline?
e4od
How do you replace a master cylinder on a 1993 Toyota Pickup?
remove brake lines, remove bolts on the bracket that holds the cylinder to the brake booster then its free. Some cases you will have to pry open the brake shoes.
Where is the fuel pump on a 1993 4 cylinder dodge spirit and how do you get to it?
It is in the fuel tank. You have to remove the fuel tank to access.
How do you remove the pin from the clutch line at the slave cylinder on a 1993 Chevy Z71?
you must drive the roll pin out where the line goes into the slave cylinder its a real small pin. can use a small punch or nail to remove.
How do you get to the top bolt to remove your starter on a 1993 Nissan truck 4 cylinder?
by going over the top of the bell housing
How do you remove the pickup coil from a 1993 Chevrolet S10 4.3 6-cylinder?
remove the distributor cap remove the screws that attach the pick coil to the base of the distributor and replace in reverse order
