you must drive the roll pin out where the line goes into the slave cylinder its a real small pin. can use a small punch or nail to remove.
You will need to remove the transmission to replace the clutch slave.
It is inside of the transmission bell housing. You will have to remove the transmission to service it.
You have to remove the transmission to get to the clutch slave cylinder on that truck. You can pull the engine if you want and get to it. YOUR CHOICE.
you must remove the clutch slave cylinder and line. Then unbolt the starser and install the new one
To replace the slave cylinder on this vehicle you will have to remove the drive shaft and then the transmission. The slave cylinder will be bolted to the inside of the bellhousing. The transmission is very heavy so be very careful.
Under passenger side of truck right below the starter. The slave cylinder for the clutch is in the Transmission Bell housing. You have to remove Transmission to repair it.
The clutch bleed valve on a 2.2 liter Chevy Ecotec engine is located on the slave cylinder. To find the slave cylinder remove the battery, as it is mounted underneath the battery tray.
To remove a clutch slave cylinder from as Astra gearbox, push the piston down against the spring pressure. Then release quickly.
YOU CAN'T. The clutch is either worn out are the clutch slave cylinder is bad.
You can't, there is no adjustment. Time to replace clutch, slave cylinder or clutch master cylinder. 1 of the 3.
Inside the transmission bell housing. The transmission must be removed to gain access to the clutch slave cylinder.
Either the clutch master cylinder or the clutch slave cylinder or the clutch hydraulic lines are leaking.