0
How do you remove front axle on 1992 ford aerostar got it all disconnected just cant get it out of vehicle do you have to remove rotor or shock or spring to get out driveshaft axel?
Wiki User
∙ 15y ago
Undo the lower A arm from the strut. Use a strong metal bar to pry the arm down then the strut swings out and the axle slides free.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
How do you remove a driveshaft off of a peugeot 406?
This is a complex procedure, get a manual for this vehicle.
How do you remove the rotors on a 1992 ford aerostar?
How do you remove the rotors on a 1992 ford aerostar?"
How do you put a 2wd JEEP liberty in towable mode?
You have to remove the driveshaft to flat tow a 2wd Jeep.You have to remove the driveshaft to flat tow a 2wd Jeep.
How do you change the half shaft on a 95 Nissan Altima?
# Raise and support vehicle, then remove wheel. # Unfasten brake caliper assembly, leaving brake line attached. # Remove tie-rod ball joint from knuckle, then separate driveshaft from steering knuckle by tapping on driveshaft. When removing driveshafts, cover boots with cloth to prevent damage. # On models with automatic transaxle , if replacing both driveshafts, remove righthand driveshaft before removing lefthand driveshaft. # Use a large screwdriver to pry driveshaft out of transaxle. # Reverse procedure to install.
How do you change the battery on a 1997 Ford Aerostar?
Remove the battery cables. Remove the battery tiedown. Remove the battery from the Aerostar. Reinstall in reverse order.
How do you remove the rear wheel off of a 1993 Ford Aerostar?
Jack up the vehicle and remove the lug nuts. To remove the lug nuts you will have to turn them to the left or counter clockwise. Then you remove the wheel by pulling it toward you. If you reverse the procedure you can reinstall it.
How do you change a track in a snowmobile?
Easy, step one: loosen the idler wheel tensioners. #2 remove the bolts that hold the skid to the tunnel and remove skid #3 remove chaincase cover and driveshaft bearing #4 remove speedometer cable from clutch side driveshaft bearing cover and driveshaft bearing #5 slide driveshaft towards chaincase enough to slide the track out.
Can you remove armrest from ford aerostar?
Yes.
Where is the fuel pump located in a 1986 jeep comanchee?
In the side of the gas tank, near the driveshaft, it is easier to remove the fuel pump if you remove the driveshaft first
How do you remove the center support bearing from a 2001 Chevy silverado 2500HD?
The entire driveshaft and stub shaft must be disconnected from between the differential and the transmission. After removal, make match marks on all parts to ensure correct re assembly. Dis-assemble the driveshaft until you are able to remove the yoke that the center support bearing is attached to. Press the yoke out of the bearing and then back into the new bearing.
How do you remove drive shaft 1996 probe?
remove nut in center of rotor lift vehicle & separate ball joint pull drivshaft out of rotor/hub assembly as you swing spindle out of the way pull or pry out driveshaft
How do you remove drive shaft on 206?
The driveshaft is held in place by an u-joint on each end of the driveshaft. Each u-joint is held together by two retaining plates. The retaining plates have to retaining bolts. Remove the retaining bolts and the driveshaft will come free.
