0
How do you remove front bumper cover of a 1988 Subaru XT coupe?
Wiki User
∙ 14y ago
From Factory Service Manual
Bumper
Front Bumper
REMOVAL
1) Position vehicJe on a lift.
2) Set headlights to upper beam.
3) Remove battery.
4) Raise vehicle.
5) Remove mud guards.
6) Remove undercover and air dam skirt.
7) Remove bolts which secure lower duet.
8) Remove bolts which secure side bumpers.
9) Remove bolts which secure lower side of side duct.
10) Remove bolts from the back of bumper stays
11) Lower vehicle.
12) Remove washer tank.
(1) Disconnect hose from check valve on the· back of front bumper.
(2) Remove bolts and washers which hold air cleaner.
(3) Remove clamp from boot (B) ASSY.
(4) Remove air cleaner and then remove conical nuts which hold washer tank.
Be Sure to turn wheel completely to the left before removing washer tank!
13) Remove bolts which secure upper side of side duct, and
remove side duct.
14) Extract front bumper with help of co-worker.
Be careful not to damage harness.
15) Disconnect front combination light harness connector.
16) Remove front bumper.
The FSM (Factory Service Manual) has pictures as well, but loading them is a pain.
Go here to find the entire thing http://www.mikeshoup.com/docs/fsm/ 88xt/Section 5-1 Page 25
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How do you remove the front bumper from a 2002 Hyundai Santa Fe?
Remove the screws in the wheel wells and underneath the plastic cover to remove the bumper cover. Then you can see to remove the actual bumper.
Where can i find a manual showing how to remove a rear bumper cover on a 2002 subaru impreza outback sport?
Factory service manuals that have been scanned and converted to Adobe Acrobat files are available for just a few dollars on eBay. Although I cannot tell you that I have seen the instructions to remove the bumper cover in these manuals they have the most complete instructions available since the original paper manual is put out by Subaru.
How do you replace a headlight assy on a 2008 Subaru Outback?
Not an easy task since you have to remove the Front Bumper Cover to get access to it. Once that's done, remove the electrical connectors, the screws and the Headlight Assembly.
How do you remove the headlamps on a 2000 Volkswagen Jetta?
REMOVE TWO TOP BOLTS ON HEADLAMP ASSY. THEN REMOVE BUMPER COVER, THATS RIGHT THE BUMPER COVER, THEN REMOVE TWO BOTTOM BOLTS
Will a 2004 Infiniti G35 Sedan Rear Bumper cover fir on a 2004 G35 Coupe?
No. The coupe and sedan have completely different front and rear bumpers.
How do you remove the rear bumper cover on a 1993 Ford Taurus wagon?
To remove the rear bumper cover on a 1993 Ford Taurus wagon, the lights need to be disconnected in the rear. Once all electrical connections are disconnected in the rear, remove the taillights and the fuel filler overflow hose. Remove any nuts and bolts holding the bumper cover on. Using needle nose pliers, pop the push pins around the bumper cover upwards. Slowly pull on the bumper to remove it.
How do you remove engine cover on subaru legacy?
ok
How do you change the fog light 2005 Subaru Outback wagon?
Turn wheel fully in for easier access. Remove clips from bottom of bumper cover (2 ea). Pull mud guard away from bumper cover. Disconnect plug. Remove cover by rotating counterclockwise. Change bulb. Reinstall cover & connector. Verify operation. Reinstall Mudguard. Put wheels straight so wife won't scratch car.....
How do you remove bumper cover from 1996 blazer?
rip it off
How do you remove rear bumper cover for a 2000 Buick Lesabre?
,
How do you remove rear bumper on a 2002 Elantra?
1. If needed raise vehicle and support it on Jack stands 2. Remove the retaining screws in the wheel wells and along the upper and lower edges of the bumper cover. Remove the tail light housings. Remove the rear trim plate and pull luggage compartment trim out for access then remove the remaining bumper cover retaining screws. Remove the bumper bolts 3. On station wagons remove the rear window washer fluid reservoir for access to the bumper retaining bolts. The remaining bumper bolts are accessible from below 4. Pull the bumper and cover assembly out and away from the car
How do you remove front bumper from 1994 Intrepid?
Unbolt the front of the wheel well liner inside the wheel opening.Remove the bumper cover bolt from the bracket located inside of the bumper at the end.AT the front of the car, remove the bolts holding the bumper cover on, located underneath the vehicle.You should now be able to remove the bumper cover from the front of your Dodge Intrepid.An instructional video has been included to show you the removal process.
