0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you remove the harmonic balancer on a 1997 Grand Prix?
Remove the right front wheel and inside fender skirt. Remove the serpentine belt. Remove the bolt at the center of the balancer. If a 3.8L engine, use special tool to pull balancer off, otherwise use hands to pull it off, wiggling as necessary.
What size bolt holds on a harmonic balancer for a 1997 dodge avenger?
22mm
Does a 1997 Mazda Protege have a harmonic balancer?
Should be the tensioner that the Alternator belt goes to
How do ichange harmonic balancer on driveshaft of 1997 ranger?
change car buy new one
Where is the crankshaft position sensor on a 1997 gmc Yukon?
front of engine, behind the harmonic balancer
Are the threads right or left hand on 1997 regal harmonic balancer bolt?
Right handed.
Where is the crank sensor located on 1997 grand prix gt 3.8 liter?
the ckp for the 3.8 is located at the harmonic balancer on all applicatins remove the right side (passenger) tire and also the plastic shroud, you should be able to access the crank sensor from there You'll have to pull your harmonic balancer to change the crank sensor.
Where is the harmonic balancer on 1997 Oldsmobile aurora 4.0 v-8?
bottom pulley. at end of crank.
Where do you find the crank position sensor for a 1997 buick lesabre?
its behind the harmonic balancer attached by two bolts but you must first take off the balancer to get to it
Timming mark on a 1997 Chevy 5.7?
There is a groove cut in the harmonic balancer. This is the part that the loer pully bolts to.
How do you change the crankshaft sensor on a 1997 camaro?
Buy a haynes manual which will explain everything to you. You can pick one up for about 20 bucks at a local auto parts store. what engine size? most gm's in 97 are sensed by the harmonic balancer. remove balancer and replace.
Where is a crankshaft sensor on a 1997 Chevrolet Lumina and what does it look like?
Hidden behind the harmonic balancer. You will need a puller to remove the balancer. It will be black, a couple of inches long, with a wire coming out of it. The frame of it is usually aluminum, and adjustable. You will need an alignment tool to adjust the sensor.
