0
on the distributor. Remove 6 wire connector, loosen distributor, turn to gain access, 7/32 socket ground down to fit in hole. remove screws pull down. difficult to get to back screw
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Where is the ignition module located on a 1990 Ford Bronco with a 5.8L engine?
there might two one is under the dash and the other is on the distruber(sp)
What is The Wiring position for the ignition module on a 1990 Buick park avenue?
what is the wiring position for the ignition module on a 1990 Buick Park Avenue?
Where is the ignition module on a 1990 GMC 2 wheeel drive truck with 350 engine?
The ignition module is located in the distributor
How do you replace the turn signal switch located on a 1990 Ford Bronco?
You have to take apart the steering column, remove the steering wheel, remove the ignition switch, and it's a pain in the butt.
1990 ford bronco no spark new coil new dist module had spark keeps blowing coil?
Dust module
Where is the ignition and distributor located on a 1990 Chevy Celebrity?
The 1990 Chevy Celebrity engine is distributorless, the ignition is handled by a combination of the engine control module(computer) and the ignition control module. You did not mention which engine the car has. If your car has the 4 cylinder engine the ignition control module is below the intake manifold at the rear of the engine. You can follow the spark plug wires to it. The coils are mounted to the ignition control module. If your car has the V6 the ignition control module is near the starter and again you can follow the spark plug wires to it. Again the coils are mounted to the ignition control module.
Instructions on how to remove ignition switch on a 1990 Lexus LS400?
Remove the retaining ring from the top of your 1990 Lexus ignition switch. The ignition switch will slide out. Remove the wiring harness.
Where is the ignition module on a 1993 Cadillac ElDorado and what does it look like?
Referenced from 'Chilton 28540 Deville/Fleetwood/Eldorado/Seville 1990-98 Repair Manual' Page 2-10: "Ignition Module The HEI Module, acting as an electronic ON/OFF switch controls the current flow in the primary winding of the ignition coil. This switching action induces a high voltage in the ignition coil secondary winding which is directed through the rotor ans secondary leads to fire the spark plugs. It is not necessary to remove the distributer from the car. 1. Remove the distributer Cap 2. Remove the rotor" This is the Ignition module. Don't remove or replace unless you understand how and know the procedure for changing.
Ignition module location on 1990 Buick Century?
You will find the ICM directly below the coils. Just remove the coils and you will be able to remove it. This is on a 1990 Buick Century V6 3300 engine. If you have a different engine I cannot confirm the location.
How do you remove the ignition switch on a 1990 Chevy half ton pickup?
how do you remove the ignition switch on a 1990 chevy half ton pick-up?
Where is the ignition switch on a 1990 bronco xlt located?
The ignition lock is where you put the key. The ignition switch is located on the top of the steering column directly above the brake pedal.
Where is the headlight warning chime module located on a 1990 Ford Ranger 2.9?
Where is the key in the ignition warning chime module located on a 1990 Ford ThunderbirdRead more: Where_is_the_headlight_warning_chime_module_located_on_a_1990_Ford_Ranger_2.9
