Want this question answered?
To remove the door panel, there are two screws you need to remove which are located under the door handle(the one you use to pull the door to close it) ,the you need to remove the mirror adjusting knob by pulling it out, then remove the window handle ( there is plastic ring around the handle which comes between the handle and the door, you need to pull it up using a screwdriver then simply pull the handle out), then just pull the door handle out with a screwdriver from the edges or preferably with your hands.
Remove the screw inside the pull handle that opens the door from the inside. Remove two bolts from underneath handle (the one that you pull when closing the door. remove the speaker. Start with bottom corner and pry the door panel off. You will inside to remove (pull up) "the lip" or molding at the top, beside the glass, to be bale to pull the whole panel up. Also, the mirror triangular cover
remove the outside handle by lifting the handle up and removing the small clip in the underside of the handle The inside door handle? remove the screw pull towards the front then out and release the clips holding the lock and open rods
remove inner door panel for access to lock
pull inside door panels off and unbolt the handle from the door from the inside, install new gasket and rebolt handle.
First you have to remove a small cover on the door and rest(inside the bucket door handle). Then you remove a cove that have the door opening handle,also remove a clip on the upper backside of the door panel(is like a little plastic screw. Then you pull the door power window controller and unplug the contoller. Then carefully pull the panel from the side be careful with the panel clips.
prybar Well first, remove the screw down in the closing handle, the pop off the piece of plastic around the inside door handle, remove the screw from in there, the grab the handle and pull straight up real hard. When removed, disconnect switched and door panel light.
If its the cables inside you need to remove the panels and replace the cables. You can in a pinch just disconnect them from the handle. Then pull them to release the door.
Pop off the red reflector on bottom. Remove screw that's there. Pry off inside part where power lock, window and mirror buttons are, starting away from inside handle. Slip this off the door handle, be careful with wires. Remove small gounding screw and then jst pull up and inside trim will come off. Assembly is reverse.
First remove the screw. Then slide the door handle back about 1/4 inch. Then gently pull the handle out about 1/2 inch. You will need a screwdriver to push the plastic clip off the metal rod that opens the door. Lift up handle and remove from rod.
You must first remove the cover from behind the door open lever and the cover from the door handle....then remove the screws.... then remove the cover for the mirror that's on the inside its snaps off so a firm pull should do the trick, and then the same for the door it has like 20 or 25 snaps that all have to be undone... a quick pull will snap it out and then I'm sure you can figure the rest out :-)
remove plastic covers on the ends of the handle...under those there are 2 bolts...remove them...i think they are 10mm...then remove the cover behind the door latch(used to open door)...inside, beside the latch...there is another 10mm bolt. remove it. pry out the window control switch from the front. pull it out. unplug the switch from the wiring harness. grab the handle of the door, then pull upward.