You have to remove the calibar which is removed by the two pins that is held on by the two pins on the calibar. Most times these bolts are 3/8 heads Allen wrench. Then the calibar should lift off.
what are the steps to take off transmission from a Oldsmobile cutlass supreme
Oldsmobile didn't make a Cutlass Supreme in 1998
how do i remove the front fender to 1996 Oldsmobile cutlas supreme.
Where is thermostat on 97 Oldsmobile cutlass supreme 3.1 Liter. How hard is it remove.
its computerized ma man.
Take out the screws that hold it on.
First, remove the thermostat housing. Then grab the thermostat by hand and remove it.
inside gas tank,remove tank.
Check on the passenger side firewall may have to remove plastic cover
Remove the power steering hose. Remove the power steering belt. Remove the power steering pump retaining bolts. Reverse the process to install the new power steering pump on your 1985 Oldsmobile Cutlass.
Bottom of radiator. If it has none then remove the lower radiator hose to drain the radiator.
To fix the outside door handle on a 1993 Oldsmobile Cutlass Supreme 2-door, remove the trim and access the mounting screws. Remove the nuts and disconnect the linkage rod by flipping the small clip and sliding the rod out of the handle. Reverse procedure for installation.
First you remove the lower back seat, and the bolts that secure the upper will be exposed. Remove them and lift out upper back seat.
if there are no bolts in the door jamb then they are welded in and need to be ground down and new ones welded on
sad to say.but i do not know either... i have a 1994 cutlass supreme sl and am looking for the same answer. if you hapen to find the answer. i would appreciate it if you would contact me at email@example.com thanks
Remove lower caliper bolt (actually the upper one is a pin), lift the caliper, replace pads. The clips and the bracket might however need some cleaning.
where is the knock sensor located on 93 cutlass ciera
Remove the wiring harness from the back of your 1995 Oldsmobile Cutlass blower motor. Remove the blower motor retaining bolts. Remove the fan from the front of the blower motor. Reverse the process to install your new blower motor.
Best left to a pro unless you want to decapitate yourself.
take inside door panel off or loose enough to get to the 3 nuts that hold the mirror on.
You have to remove the passenger side wheel, and inner fenders, then the drive axle and heat shield, then you can get at it. From underneath.....sorry.
After you remove top plate, hoses,trans lines, fan & shroud it should lift straight up.
On my 1996 Oldsmobile cutlass supreme it was very easy to remove the stereo. The entire plastic molding piece that surrounds the stereo as well as covers the speedometer is attached by some push clips and can be simply pulled off, no screws. Once the plastic surrounding is removed there will be 2 screws holding the stereo in place. Remove the 2 screws and pull the stereo out. Unplug the wire harness and antenna.
Begin by removing the decorative radio retaining cover. Remove the retaining bolts. The radio will slide out. Remove the wiring harness and the antenna cable from the back of the radio.