Want this question answered?
remove cable from the transmission and remove the cable from the back of the speedometer up under the dash and then the complete cable can be pulled out.
Remove speedometer head to unscrew and remove cable Remove cable from transmission Re-Install new cable using same routing as original
The seat is removed using a pull ring behind the seat, under the rear fender and taillight. It is a cable with a loop in it. Pull the loop, lift the seat.
Remove - battery cable Remove + battery cable Remove hold-down bolt on front bottom of battery tray Remove battery
1. Remove negative battery cable 2. remove positive battery cable 3. remove battery 4. install new battery 5.attach positive cable 6.attach negative cable
Remove speedometer head Disconnect old cable Follow original routing for new cable Disconnect fitting at side of transmission and remove cable - replace with new
There is no cable, it is hydraulic operated.
You have to drop the trans pan to do it. Remove the cable from the carb and bracket. There is one bolt where the cable runs into the trans. Remove that bolt. After dropping the pan you'll see how the cable is mounted inside the trans. Remove the retaining clip and pull the cable out. Reverse for installation.
1. Take the tension out of the cable by loosening the adjustment on the cable. 1/2" and 9/16" wrench required. 2. Take the Allen screws out of the right side transmission cover. (may have to remove exhaust to do so. 3. Remove C-clip holding clutch mechanism inside the trans cover. 4. Remove cable from clutch mechanism and unscrew cable from trans cover. 5. Remove pin on handlebar lever and remove cable from lever. To install reverse removal instructions ***Note*** Be careful when threading new cable into trans case. DO NOT over tighten you will break the new cable
Remove the air intake box and look beneath the master cylinder and you will see the shift cable. unbolt it from the transmission using the appropriate socket and undo the shift cable. on the inside, remove the center console and undo the cable inside as well
Remove - battery cable Remove + battery cable from battery and starter solenoid Route new cable following original routing Connect to starter solenoid Connect to + battery terminal Connect - battery cable
Buy the Cable , then remove the screws that hold the broken cable and attach the new cable back.