Clutches and Flywheels
Water Pumps
Dodge Durango

How do you remove the clutch fan to get the water pump off to replace it on a 1999 Dodge Durango?

767778

Top Answer
User Avatar
Wiki User
2015-07-15 21:09:15
2015-07-15 21:09:15

If it is like a dodge van the clutch fan has a large nut on the back of it you need to trun it counter clockwise to remove it,it might have locktight on it so you will need to leave the belt on and apply preasure to it as you turn the nut and try some heat some times that will work,be carefull not to bend the fan they are balanced,a bent fan will wear out the new waterpump.

It is exactly the same as the van.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

If Possible Get rid of your Clutch Fan and go Electric! But to answer the question, remove serpentine belt and use a strap wrench to stop clutch from spinning when you try to remove fan clutch nut from water pump!

User Avatar

link here: http://www.craigcentral.com/durango/speakers.asp

User Avatar

how to remove lighter socket from 2013 dodge durango console

User Avatar

You have to remove the trans oil pan to change fluid.

User Avatar

Behind the instrument Cluster. Or remove it and replace the Cluster.

User Avatar

With another Headlight Assembly that is made for a 1999 Dodge Durango.

User Avatar

How do you replace a slave cylinder on a 1995 dodge neon clutch

User Avatar

located at the end of the upper radiator hose. remove two bolts, replace with new parts remember to replace the gasket.

User Avatar

How to replace the inside Spectra Heater Core on a 2000 dodge durango??

User Avatar

You can remove the headlamp and drill a small hole in the bottom but this is not recomended.the correct way is to simply replace it

User Avatar

How do you remove drive shaft from a 03 durango

User Avatar

Answering "How do you replace the brake pads on a 2004 Dodge Durango limited with anti lock brakes?"

User Avatar

Take belt off water pump pulley remove fan from pump (4 bolts) remove old clutch from fan install new with same bolts Put fan back on.

User Avatar

i want to replace the auxiliary water pump on my 2005 dodge durango. will you please provide a video to show me exactly where it is located and how to replace it? thank you

User Avatar

Using a special clutch fan tool to hold the fan still, remove the fan nut and take the fan off of the dodge 360. The tool should be available for rental from a local auto parts.

User Avatar

From behind the light bezel (under the truck) quarter turn and remove the lamp holder. Replace with an "893" type bulb

User Avatar

1. change the thermostat. 2. radiator flush (possibly clogged) replace if bad. innerauto.com $150 3. fan clutch not turning possibly (replace) 2 & 3 destroyed my 4.7L engine in my 2002 Durango. You will get check gauges on dash.

User Avatar

Clutch slave is seled unit. replace clutch

User Avatar

The fuel filter is in the gas tank therfore u must remove the tank to replace it If it's like a 99 durango, it's part of the fuel pump and the whole thing will need to be replaced.

User Avatar

The average cost to replace a shift solenoid on your Dodge Durango is $175. The shift solenoid will cost approximately $50 and two hours of labor.

User Avatar

Dodge Durango was created in 1998.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.