0
How do you remove the dash in a 1989 g20 or even how do you replace the speakers in the dash?
Wiki User
∙ 17y ago
You can go to Crutchfield and they will send you the intricate details for this job. It is a pain. The heater has to be removed and the dash, it is difficult and time consuming.
Wiki User
∙ 17y ago
Add your answer:
Earn +20 pts
How do you replace the dash speakers in a 1998 Chrysler Cirrus?
Remove center stack bezel (radio, heater control), remove screws from instrument trim panel at ctr stack and remove instrument trim panel, remove dash top panel, replace speakers.
What size dash speakers for a 1972 Oldsmobile delta 88?
Dash speakers are 3 1/2 inches. They are a real pain to replace. You need to remove all lower portions of the dash.
How do you remove front dash speakers on a 1989 S10 Blazer?
Begin by removing the dashboard speaker covers on your 1989 Chevy S 10 Blazer. Remove the speaker retaining screws. Remove the speaker wiring harness. The speakers will come out.
How do you get to the the dash bulbs to replace them on a 1989 Chevrolet Celebrity?
To change the dash light bulbs you must remove the instrument panel.
How do you remove the front speakers from a 1989 Chevy Celebrity?
To remove the front speakers from a Chevy Celebrity: 1. Take out the screws from the speaker grills, take the grills out. 2. The speaker is held in with screws, remove them. Lift the speakers out of the dash and unplug the wire harness.
How do you replace the dashboard speakers in a 1991 cutlass supreme?
Answer If I'm not mistaking the dash board speakers on your car are under the dash, close to the windshield. I think you would have to remove the entire dash to be able to get at them so do yourself a favor, put good speakers in when you install them, as taking the dash apart is one heck of a job.
How do you remove the rear dash panel to replace the rear speakers on a 1989 Buick Park Avenue?
What you have to do is remove the brake lights which is located in the middle of the rear windsheld. You have to remove 2 or 3 screws. Once you have done this look at the carpet and you will see. A divider line. Just lift up the carpet and you will see the rear speakers. Just remove the speakers and there you go. Once you have installed the new speakers. Just lay the carpet back down on it's appropriate side.
How do you take out dash speakers in a 2007 Jeep wrangler?
Remove the side panels closest to the doors and unscrew the top screws on the dash. Once you remove it will be easy to take out the stock speakers and replace them. I replaced mine with a pair of Alpine Type S SPS-600 Speakers, this makes a huge difference. Good luck!
How can the dash speakers in a jeep liberty be replaced And what kind of speakers are they so they can be replaced?
The type of speakers used in the dash of a Jeep Liberty are called tweeters. These units are small speakers that off one specific type of sound such as bass. To replace them remove the top section of the dashboard. Then remove the speaker mounting screws. Unplug the old units and plug the new ones in.
How do you remove the dash speakers on a jeep commander?
just remove the grills off the speakers with a flat head screw driver
How do you remove the factory speakers from your 92 grand am se they are the premium speakers if that matters?
Remove the dash pad, then remove the speakers from the dash frame. For the rear speakers, open the trunk and remove the brackets, that hold the speakers in place. not for the back speakers ..you have to remove the lower rear seat then remove the seat belts then the rear seat back then remove the header panels in the back seat then remove the deck cover ..the rear speakers are bolted in from the top down under the rear deck cover....and the front speakers i believe are mounted in the door panels in the front doors ..you have to remove the door panels to remove them .some do have them in the dash also if they are there u do as the person stated before me.
How do you access the dash speakers in a 1992 grand prix se?
In order to remove the speakers, you must remove the "Dash Pad". It's held in place with clips and a couple screws. Start by pushing up in the center of the dash pad. Then remove the screws.
