answersLogoWhite

0


Best Answer
Copy

You do not need to remove the dash.

Take out the ash tray (by pressing down the lever as you pull it out)

Starting at the sides, pull firmly on the plastic trim through the ash tray opening.

The trim will start to pop off.

Be careful not to pull to hard, as the trim is attached by small plastic tabs with metal clips on the end you may break them and not be able to get the trim piece back on.

There are two on the bottom, two in the middle and two at the top (Will vary on car package).

Once you pull it off, you'll see the two bolts holding the radio in.

Remove these two bolts and slide the radio out.

TIP: When installing the new radio, try to find a harness adapter. It will make installation easier and cleaner.

If at any time you cannot purchase an adapter, cut the wires 2 to 2 1/2 inches from the plug the is in your dash.

When you sell the car in the future you may want to replace the stock radio back into the car.

By cutting 2 to 2 1/2 inches from the plug you can re attach it for the stock radio.

Edited By Russell G.

User Avatar

Wiki User

โˆ™ 2015-07-15 19:06:33
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Add your answer:

Earn +5 pts
Q: How do you remove the dash on a 1990 Sundance to replace the radio?
Write your answer...
Submit

Related Questions

How do I remove a 1990 Lexus es250 radio?

To remove the radio from the 1990 Lexus ES250, first pry the face plate from the dashboard. Then remove the clips that hold each side of the radio. Then, remove the wires to release the radio.


How do you take the factory radio out of a 1990 Chevy Caprice?

Begin by removing the decorative cover from your 1990 Chevy Caprice factory radio. Remove the radio retaining screws. Remove the wiring harness and the antenna cable from the back of the radio.


How do you remove a radio from a 1990 Nissan Micra?

you have to remove the ash tray first - small screw at top, pull that out, then remove the two screws under the radio, then you can pull the radio out.


How do you replace the radio antenna on a 1990 Jetta Volkswagen?

To replace the radio antenna on the 1990 Jetta you simply unscrew it (counter-clockwise) and screw the new one clock-wise. If you are replacing antenna with off the shelf product You will probably have to remove the wheel, wheel well fender protector, to have access to the bolt for the antenna


How much does a 1990 plymoth sundance fuel pump cost?

How much does a 1990 plymoth sundance fuel pump cost?


How do you remove dash board to get to the radio in 1990 Chevy Lumina?

with a crowbar


How do you remove and replace the power steering pump in a 1990 Toyota Camry?

how do i replace a power steering pump in a 1990 toyota camry?


How do you remove and replace a heater core on a 1990 Toyota Celica?

== ==


How to remove a radio from a 1990 buick lesabre?

the black trim around the ac control pops out and then there are four scews you need to take out then remove the wires and the radio is out.


What film festival started in 1990?

Sundance


How do you replace a stock radio on a 1990 v w passat?

Insert 4 small pins in the holes on the front of the radio and pull out.


How do you remove a radio from a 1990 Mazda miata?

See http://www.miata.net/garage/miata_radio_removal.html


Where is the fuelpump on a 1990 Plymouth Sundance?

In The Fuel Tank


How do you replace the alternator on a 1990 Buick Regal?

Disconnect the 1990 Regal battery. Remove the alternator belt. Unhook the wiring from the alternator then unbolt it. Remove and replace the alternator then reconnect the wiring, belt, and reconnect the battery to finish the installation.


How do you remove the factory stereo in a 1990 Nissan Maxima?

the acutually dash removal of the Comfort-Control Toggle Switch in order to remove facing for radio replacment of 1990 nissan maxima?


How do you remove a radio from a 1990 Lexus ls 400?

go to this website http://www.carstereohelp.com/stereoremovalLexusLS400str.htm


How do you replace the alternator on a 1990 Subaru Loyale?

Remove the wiring harness from your 1990 Subaru alternator. Remove the alternator belt. Remove the alternator retaining bolts. Reverse the process to install your new alternator.


What oil does a 1990 Plymouth sundance use?

5w30 should work fine. I have a 1993 sundance duster and that's what I use.


How do you time a distributor on a Plymouth sundance 1990?

with a clock jking


What is the oil type on a 1990 Plymouth Sundance?

5w30 or 10w30


Where is the Blinker relay in a 1990 sundance?

Under the fuse box


How do you replace an alternator on a 1990 Acura Legend?

Remove the belt from your 1990 Acura Legend alternator. Remove the wiring harness from the back of the alternator. Remove the alternator retaining bolts. Reverse the process to install the new alternator.


Where is the turn signal flasher located on a 1994 Plymouth Sundance if it's not beside the hazard flasher?

... on a 1990 Sundance there is a flasher just above and behind the radio - it seems to control the right side flashers. The 'bezel'type trim piece surrounding the section of the dash containing the radio can be pryed off. I would sure like to know where the flasher for the lights on the left side is ...


Do you need to remove the engine to replace the transmission in a 1990 Acura Integra?

No but to me it's just easier


How do you replace an EGR valve on a 1990 Chevy Silverado?

disconnect the hose and remove 2 bolts.