i think it you just unclip it on the car not the van the clips are hard to see but they ar on the bottom of the trim my have to use a flathead screwdriver to pry them up and out.
It is not necessary to remove the dash. Only necessary to remove enough of the trim pieces to get the radio out. If you look carefully you will see what needs to be removed.
Are you asking about the trim panel above the glove box or the trim panel in front of the radio or the trim panel around the instrument cluster? Ask again telling us which panel you wish to remove.
under the right rear window trim.
To remove the windshield trim on a 1968 Chevy Impala you will need a trim removal tool that has slides which can release the locking clips.
first remove the dash trim, you can go to any auto parts store and buy a trim removal tool if need be. you can also remove trim by pulling straight out, be carefull not to break it. after removing trim there are 2 screws holding switch in. remove the screws pull out a bit and remove wires.
All you have to do is remove the trim from the left side steering wheel dash and then simply unbolt/remove the headlight switch.
How to remove the fake wood trim from dashboard
Either 7 or 8, depending on trim level
with a hammer
remove dash trim
To replace the radio in your Celebrity dash you must remove the trim panel in front of the radio. If you need to know how to take out that trim piece let me know what year car you have (there are two different styles) and I will go into some more detail.
to remove the dash trim around the stero unit, find the screws under the ac/heater controls that are on the trim, to remove the rest of the trim you need to remove the plate around the shifter too, so take the screws out of the shifter's plate. remove the rest of the screws around the trims and you should be able to pull the trim out of place.
Remove the dash trim above glove box. Then remove the trim above stereo, this will reveal 2 screws, remove these and the stereo slides out.
This is a very simple procedure...all you do is pull on it. The trim piece which goes around the stereo and instrument cluster is one piece and is held in by snaps. Be careful when you are removing it around the steering wheel-it can be stubborn, but moving the shift lever all the way into 1 will get it out of the way and make it easier to remove.
To remove the dash to get to the radio from a 2005 Kia Optima, begin by prying around the edge of the trim around the gear shifter. Then, remove the screws from the bottom of the dash and pry the trim away from the radio area. This will expose the radio bezel.
to remove your radio you need to remove the dash trim first... remove every screw you can find in the dash trim (plastic trim) most of the screws are on the bottom and near the ashtray the top snaps into place (try pulling downward on the trim after you remove all the screws). once you have this removed, there are 2 screws top and bottom of the radio, remove them and the radio will come out, the rest is easy.....
Remove center stack bezel (radio, heater control), remove screws from instrument trim panel at ctr stack and remove instrument trim panel, remove dash top panel, replace speakers.
The dash has to be removed which is a HARD job. I suggest taking it to an auto trim ahop.
Squeeze the center with your hands near the metal trim. It will come off
Remove the dash trim piece,the one with the plastic that covers all the instrument panel. It snaps on and will pull off. This will expose the screws that secure the radio to the dash. After loosening the radio, the wiring can be disconnected.
1. Remove the trim around the radio. This will be the whole dash trim on the driver's side. 2. Remove 3 x 7mm screws that are holding the radio in place. 3. Unhook the 3 connections (2 x wiring harness and 1 x satellite cable).
The flasher is part of the hazard switch and they are replaced as a unit. Remove the trim piece from the dash. This is attached with screws in some places and press fit in others. Once the trim is loose it is a simple matter to replace the switch.
to start off you have to pull off the dash trim around the raideo and the dash. once you do that their are 2 clips one on each side of the raideo you just push them down and pull and out comes the raideo.
all the trim panels are held in by clips and they just simply snap off