gently pry it off with a small screwdriver.. also everyone should have a manual for their vechicle, and the library should have a professional shop manual available in the reference section for FREE to make copies of--the PRO manual has more detailed info, and may have wiring diagrams when needed...read up and fix 'em like a PRO...good luck Dave :)
Follow top radiator hose toward engine. remove bolts holding housing to engine. remove housing. remove old thermstat & remember how it was in there. (spring toward engine) remove old gasket from emgine & housing. Now reinstall new gasket & thermstat
Drain the radiator. disconnect the top radiator hose from the engine. Remove the water inlet that the hose was hooked to. The thermostat is in the housing. Replace the gasket when replacing the thermostat.
It is at the end of the lower radiator hose on the motor. You will have to empty the radiator and remove the housing to replace it.
Remove the shield on the front lower side of the bell housing.
You have to remove the fuel tank or truck bed to access it.
How do I get to the flywheel bolts on a 98 dodge dakota to remove a transmission
i had a Dakota with the V8 .and if it is like the 97 dodge Dakota it will be on the housing from the top radiator hose
The heater core on a Dodge Dakota is inside the HVAC housing, under the dash.
A 2003 Dodge Dakota does not have a cabin filter.
You will need to remove the water lines from your 1995 Dodge Dakota truck heater core. Remove the heater core retaining bolts. Reverse the process to install the new heater core.
On 2000 Dakota Sport you lower the tailgate and there are 2 Phillips head screws that you remove and the whole tail light module comes out. You can then remove the bulb socket and replace the bulb. On my 2002 Dakota Quad Cab there are 2 torx screws.
how do you fix transmission on a dodge ddakota
What all is involved in replacing a a/c evaporator in a '94 Dodge Dakota?
Follow your top radiator hose to a housing that has three bolts in it. Once you loosen these bolts you will be able to remove the housing and will see a round metal object, this is your thermostat. Watch wich direction it goes in to assure instalation is right. Good luck with your project.
The 1997 Dodge Dakota air intake sensor can be found attached to the air cleaner housing. The air intake sensor will be on the inside of the air cleaner housing.
How do you replace a transmission solenoid on a 2001 dodge Dakota 4.7 engine 4x4 location?
Follow the upper radiator hose to where it meets the engine. Remove the two bolts of the thermostat housing and remove and replace the thermostat.
You remove the compressor and replace the belt with one for a truck with out ac
Remove the 1992 Dodge Dakota inside door panel. The door handle mechanism will be visible. Remove the door handle linkage. Remove the door handle retaining bolts.
You have to pull it out.
I have 2003 Dodge Dakota Club Cab with overhead console, and need to remove the headliner to have it redone. What is the procedure for removal? Thanks Mick
You have to remove the pan to drain the fluid.
remove wheelremove brake caliperremove rotor
Remove the top and bottom radiator hoses including the transmission fluid, then remove the side mounting bolts, after that is completed, slide the radiator up and out of the engine compartment