take out the screws, one under the handle/armrest, one under the reflector on the bottom of the door, then one that holds the bezel on the actual latch you pull to open the door.
Then there is one more you need to take out, but, ya gotta look for it, i don't remember quite were it was. Its under the door panel i think that ya gotta pop the panel with the window and lock controls off to get to it. After that start at the bottom and tug till it pops of working from the bottom to the top then you lift it up to get it off. Be careful not to rip and wires loose.
its easy take ya 5 minutes
Read "How do you remove the interior door panel on a 2000 Pontiac Grand Am?" the answers are prettymuch perfect
just remove it
You have to remove door panel
In a 1988 Pontiac Grand Am you will find the clutch slave cylinder located on the flywheel. You will need to remove the hush panel from the driver's side foot well to gain access to the clutch slave cylinder.
Under the dash, left side you will have to remove the close out panel.
Using a screwdriver, remove all the screws in the door panel and remove all the clips holding the panel to the frame. Gently pull the panel away from the frame, remove an wire connectors and pull the panel off the frame.
Ihave 2000 grand prix how to remove dash board to remove radio Go to http://www.carstereohelp.com/stereoremovalPontiacGrandPrixSt2.htm
Open the driver's side door and remove the panel on the side of the dash. If not there, then the passangerside of the dash.
This should help http://documents.victorytechnologies.com//documents/product/1392.pdf
Using a screw driver, remove the screws and the clips in the panel of the door and remove the panel gently. Remove any wiring connectors between the panel and the door, then remove the panel the rest of the way.
looking for a fuse panel block 2008 pontiac
Remove the door panel, then remove the plastic sheeting. Then you can gai access to the window tracking. Remove the two 10mm nuts, that hold the window glass to the upper track. Remove the glass from the door, and install the new one in the reverse procedure.