First remove the two Phillips head screws in the rear of the center console. This loosen the console and make it easier to remove the trim around the radio. Now get a wide, thin bladed flat screw driver and pry up the inner trim from the outer console. The inner trim will pop slightly. Then pry up the inner trim from the outer console on the opposite side. Once both sides are loose, then you can grip it and gently pull it out. You will have to place the truck in neutral and in 4wd high to get it out far enough to remove the upper trim.
Once this lower trim is out, you will see two Phillips head screws forward of the shift lever, below the radio. Remove these screws. Once the screws are out, take your flat blade screwdriver and gently pry the inner trim up. Just as before with the lower trim. Once free, this upper trim will have a wire harness connecting three control. These are released from the trim by depressing the catch and pulling on the connector.
Once all three are disconnected, you will see the radio mounting bracket, which is held on by four Phillips head screws. remove these screws and pull out the radio. Disconnect to wiring harness as above to completely release the radio.
All the Phillips screws are all the same size, so don't worry about that on re-assemble. Don't forget to connect all wiring harnesses.
Good luck.
go to0 a stereo shop and buy one and have it installed go to0 a stereo shop and buy one and have it installed
send this question next week I will be replacing the stock stereo this weekend if weather permits
Remove the retaining cover from your factory stereo. Remove the factory stereo retaining bolts. Slide the factory stereo out. Remove the wiring harness and the antenna cable from the back of the factory stereo.
Remove the 2002 Dodge Durango factory stereo decorative cover. Remove the factory stereo retaining screws. Pull the factory stereo out. Remove the wiring harness and the antenna cable from the back of the stereo.
How do you remove stereo from 2000 nissan pathfinder?
color codes for wiring on factory stereo on 2008 Nissan sentra?
you have to remove the front console. take out the ash trey. and remove all the screws around the trim of the area of the stereo and then slid the stereo out and un hook all connections. if you get a new stereo it should have more detailed instructions
the acutually dash removal of the Comfort-Control Toggle Switch in order to remove facing for radio replacment of 1990 nissan maxima?
http://www.metraonline.com/downloads/pdf/TurboKits/INST95-7419.pdf
Yes
AnswerIt's located under the factory stereo in Premium sound models. Here's a link to show you where and how to remove it!Good Luck!-Shaun-
To remove the factory stereo on 1996 dodge ram 1500 you need to pop the hood on the Ram and remove the ashtray. Slide the stereo out of the dash and unplug the cables from the back of the stereo.