tap outward on flange area to "pop" it out off the C-clip retainer/ install same way.
Remove the positive battery cable from your 1987 Chevrolet Blazer battery. Remove the starter cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install the new starter.
The year of your Chevrolet Blazer will determine whether it has front shocks for front struts. Front shocks are held in place by a retaining bolt on each end of the shock. Remove the retaining bolts and the shock will come off. Reverse the process to install the new shock.
In front of the engine behind the a/c condensor
You will have to remove the transmission and pull the toqure converter out of the front of the trans. then you will see a seal in the center of the trans. Remove it with a screw driver, then clean and install new seal it will drive in with a hammer if your good. You may need a seal driver.
on the intake manifold front of motor on top
in the pump on the front of the motor thingy
Lower left front side of engine.
UNDER HOOD, DRIVER SIDE, FRONT ENGINE AREA, BELOW EXHAUST MANIFOLD, MOUNTED IN ENGINE BLOCK.
how do you replace seatbelt retractor on a 2000 chevy blazer
My 93 s10 Blazer has torsion bar suspension and I suspect yours does too, which would make it independent front suspension.
very carefuly
The front hub and bearing assemblies are the same for left and right side.