answersLogoWhite

0


Best Answer

no they are slip on just remove holding rings from lug nuts if they are there (they are for the factory not needed after assembly) and smack old rotor with hammer should pop off and slide on new ones good luck

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you remove the front hubs on a 1988 full sized Chevy blazer 4x4 for a rotor relacement?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do i remove the front fender from a 2000 Chevy blazer?

very carefuly


Remove front inner door panel on 2004 Chevy blazer?

luck


How do you remove the front signal lights on a 2000 Chevy Blazer?

a repair guy needs to do that for you.


How do you remove heater case 2003 Chevy blazer?

Open both front doors and remove everything between the firewall and the front seat :(


How do you change the starter on a 1997 Chevy Blazer?

Remove the positive battery cable from your 1997 Chevy Blazer battery. Remove the cables from the front of your starter. Remove the starter retaining bolts. Reverse the process to install the new starter.


Where is the radiator on Chevy Blazer?

In the front


Heater box removal 1999 Chevy blazer?

Open the two front doors and remove everything from the front seat to the firewall, I'm not kidding.


Will a 2001 Chevy Blazer front clip fit on a 1995 Chevy Blazer?

NO, It is all different. Won't work.


How do you remove front dash speakers on a 1989 S10 Blazer?

Begin by removing the dashboard speaker covers on your 1989 Chevy S 10 Blazer. Remove the speaker retaining screws. Remove the speaker wiring harness. The speakers will come out.


How do you take the 4 wheel drive off on a 1989 Chevy Blazer?

you dont, if you want to disconnect it then remove your front drive shaft.


How do you change the shocks on a 1997 Chevy Blazer?

a 4 door 97 blazer front how do i do it


Chevy blazer 99 front door panel removal?

i think you should remove the door first then remove the door panel by hitting it with a soft hammer to release it.