Look under your seats the rails for moving the seat back and forth there will be some bolts that go into the floor. Simply take out the bolts and make sure to unclip any wires so not to damage them, and this should do it.
they both have to be front or rear wheel drive, you cant do it if one is front, and the other is rear
it is right underneath the front of the tranny no way you can miss it.
unscrew it unscrew it unscrew it unscrew it
Easy as pie. Remove the 2 black nuts at the front of the cover. Pull up the front edge and swivel the rear edge out of the clip that holds it down.
If all seats are occupied and everyone has a seat there are 36 seats
The Oldsmobile Cutlass Ciera a was front wheel drive model. It was sold by General Motors from 1982 to 1996.
you need to remove the black plastic air dam that is covering the bottom of the engine. The starter is then accessible at the front of the motor
Remove the wheel, the calipers and the rotors, reverse procedure with new rotors.
Remove the positive cable from your 1997 Oldsmobile battery. Remove the starter cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install the new starter.
It just bolts into the floor. IIRC, it should be four bolts through the brackets in the base of the seats. Unbolt them, and it'll pull right out.
You need a 3/8 Allen key.
To Change the antenna, its best to remove the right front tire. Then remove the plastic wheel well cover and wella, the antenna can be easily replaced.
I am trying to do this myself,any suggestions ========== Do not turn transmission! I myself, 8/29/09
Thair is a pin in the front of the shifter, use a flat head screw driver and pop it in pull off.
Standing in front of the engine, its on the left side of the engine intake. You'll have to remove that MAP sensor to get to the PCV Valve.
Remove the body brace over it. 1 bolt in the back, 2 in the front. Remove the battery mount. One bolt on the front of the battery (kind of faces the engine). Disconnect the battery lift out, replace. Reverse disassembly. Rich
I need to know where the timing chain is located in a 1988 Olds 98 regency brougham, and how expensive a timing chain is.
yes, most of the panels can be used from one to the other
There isn't a distributor cap it has a coil pack and it is located in the front passenger side it is a rectangular box that the plug wires are connected to
There should be a lever on the bottom of the back seat. It is located on the lower corner of the back seat, and it allows the back seat to come out in one piece.
The ECM is located under the coolant reserve tank and mounted to the front of the strut tower. Only a single nut holds it in place. once you remove the nut simply pull it out.
olds cutlass calias bolt removal. you must remove the air box, the radiator cooling fan and anything else that is in your way from accessing the alternator from the top, front of the car. a longer extension on a 3/8 drive ratchet and the proper size socket,13mm or 15mm should remove this bolt.
Remove the wiring harness from the back of your 1995 Oldsmobile Aurora blower motor. Remove the blower motor retaining bolts. Remove the fan from the front of the blower motor. Reverse the process to install your new blower motor.
The rear deck comes out in one piece, to remove first remove the the seat base there will be 2 ring pulls under both seats then remove the seat back there will be 2 nuts on the bottom and 4 on the top under the seat backs (folded down) then the rear deck is held on with push pegs in the front and there are two slots in the back by the window that you have to push down on the deck to unhook then the whole rear deck comes out and there will be 4 screws in each speaker