2005 Toyota tacoma how to remove the brake rotor
how do i remove the brake rotors for a 2003 Toyota tacoma v6 2wd
Heres a write up on how to remove a radio in a tacoma 2005 -2013 http://freecarsupport.com/diy-write-ups/2012/9/17/how-remove-install-a-radio-in-a-2005-2013-toyota-tacoma
Where is the fuse or relay transmission lever of Tacoma 2006
To remove a radiator from a 1997 Toyota Tacoma the truck needs to be cooled down. The coolant needs to be drained, and loosen the radiator mounts. When everything is loosen remove the radiator.
Take the screws out of the radio and pull it out!
The answer is the same as for a 2004 Tacoma. See the response here:How_do_you_remove_the_factory_radio_on_a_2004_Toyota_Tacoma
Call an Auto body guy
You can change the spark plugs on the 1997 Toyota Tacoma yourself. Remove the ground wire and spark plug wire. Remove plug. Replace the plug with a plug made specially for your model car.
Remove a battery connector. Remove the starter and put another in it's place.
To remove the drum, beat it mercilessly with a very large hammer.
Remove all interior moldings that touch the headliner, the sunvisors and dome lamp and pull it down.
It's all bolts not like the easier to remove larger tailgates like on alot of full size pickups.
Remove ashtray remove 2 screws holding holder in place pull outdo tierce fly with pliers remove bulb gently with pliers
You should remove the positive cable from your 1996 Toyota battery. Remove the cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install the new starter.
Remove the lower bolt from under the truck. Remove the upper bolt by removing the left front wheel and getting to it though the wheel opening. Not easy, I just changed the one on my 2.7 Tacoma last year.
There should be two screws on the underside f the handle. Remove those, and the handle will come right off.
If you can't get to the back of the light assy you have to remove it from the vehicle and the bulb screws in.
how to replace the rear bearings on a 1999 Honda fourtrax ATV
Remove the lower timing belt cover and then the sensor should be to the right of the crankshaft pully.
remove the bolts holding on the plastic paneling under the steering wheel in the interior. remove the two bolts connecting the hood release latch from this plastic panel. then remove the panel. the circuit opening relay is under this panel, and is green(in my 1997 tacoma).
Not sure of the V6 but, on a 2.7L A/T, the fuel filter is located underneath exhaust manifold (two pieces), remove all hoses, throttle body, and the exhaust manifold, inspect/clean the injectors since your in there. Super Mario sendz.
Get out a hammer and smash of the windmirror, a chain saw also works well though
When changing the spark plugs on a 2006 Toyota Tacoma make sure the vehicle is off. Use a spark plug socket and pull the spark plug wires. Remove the old spark plugs and properly space and install the new parts.
Remove the door panel and there should be about 3 nuts/screws holding the mirror on