Want this question answered?
how to remove lock cyliner switch 1988 Isuzu pickup
If your 1988 Chevy Corsica key only turns in the ignition and does not start the automobile, it is probably unfixable. Remove the ignition switch retaining ring. Slide the out and remove the wiring harness. Reverse the process to install the new ignition switch.
Ignition switch and lock cylinder removal 1988 Dodge Ram 50.Disconnect the negative battery cable from the battery.Remove the steering column cover to gain access to the ignition switch/lock cylinder.Using wire cutters, remove the cable band.Remove the bolts that hold the ignition switch/lock cylinder to the steering column.Unbolt and remove the key reminder switch and remove the switch lock cylinder from the steering column.
How do i change the ignition switch in a 1988 Chevy camaro
Remove steering wheel, turn signal (4 screws), and torx holding ignition, reverse to reinstall.
I have to jump start my Pontiac Bonneville 1988 everyday I drive it why is that.
where is fuel shut off switch for Ford Bronco eddy Bauer
The 1988 Ford brake light switch does not adjust, replace it with a new one.
In my 86 you must remove the lower column cover, diconnect battery, insert key, turn to on. Under where the cylinder goes in there is a pin, push the pin in and pull out cylinder. Can't really describe it to
You need to remove the steering wheel first with a puller. There is a latch you can trip with a small screwdriver that will let the ignition switch slide out. Simply replace the switch and put the steering wheel back on.
Remove the steering wheel. (you will need a steering wheel puller) Remove the turn signal switch. It is not necessary to completely remove the switch from the column. Pull the switch rearward far enough to slip it over the end of the shaft, but do not pull the harness out of the column. Turn the lock to Run. If necessary, remove the ignition key. If equipped, remove the buzzer switch assembly. Remove the lock retaining screw and remove the lock cylinder.
how do you remove the ignition control module on a 1988 ford f-250 pickup?