First, pry up the electric window control panel, and disconnect everything, then tuck the wires back down out of the way. Remove the door panel by removing the two bolts in the handle/ armrest then lok carefully at the trim ring around the door handle, and you should be able to see where you need to use a flat screwdriver to pop it out of place, and remove it. After that with a flat screwdriver, cats paw, or something else you can gently pry away the entire door panel from the bottom up (it kind of hangs from the "window sill" then lift up when you get to the window.
You can replace the inside drivers door handle by removing the door panel. With the door panel removed the door handle mechanism will be visible. Remove the linkage from the door handle. Remove the door handle retaining bolts. Reverse the process to install the new door handle.
yes remove door panel drill rivets replace with new door handel from gm dealership
Remove the inside door panel from your 1996 Dodge Avenger. Remove the door handle linkage. Remove the door handle retaining bolts. Reverse the process to install your new door handle.
Remove the inside door panel of your 1994 Chevy Lumina. Remove the door handle linkage. Remove the door handle retaining bolts. Reverse the process to install the new door handle.
Remove the door trim panel. Remove the inside door handle rod. Remove the inside door handle retaining rivets. Remove the inside door handle from the door by sliding the handle rearward.
there are screws in the door, and holding the handle on. You can get to the ones holding on the handle by pulling off the covers on each side of the door handle inside.
You have to remove the door panel...not easy, but do-able. Once that is off you can remove the door handle and replace it.
remove inside door panel,let window all the way up and remove related linkage and unbolt handle,installation is the reverse of removal, you'll need a 10mm socket or maybe an 11mm,remove two bolts holding handle in place.
You will need to remove the inside door panel of your Mustang. Remove the linkage from the outside door handle. Remove the outside door handle retaining bolts. Reverse the process to install the new outside door handle.
Remove the door panel.Remove the bolt from the inside of the door that holds the handle on.
Remove inside trim panel (incl. around the window) With a light you'll see 2 12mm nut at the back of the door handle There a small metal clip that hold the rod to the handle
First you need to remove the trim bezel around the handle on the outside of the tailgate. Then remove the three bolts on the inside of the tailgate,that hold the handle in place. Next remove the latching mechanism rods from the handle,and remove the handle from the tailgate.