First isolate the electronics via battery and fuse panel.
The passenger air bag panel does not come off separate from the bag module. Do not pry it off.
Inside the glovebox are there are bolts (@10mm) to be removed from the front and underside. Also the glovebox latch catch will need to be removed.
The bag and panel will then slide out partially. The electrical connector can be removed (not always necessary). Just slide the air bag housing forward without straining the connection.
The dashboard can then be loosened via screws and when completed reverse the procedure for re-installation.
remove the complete dashboard and then replace it
It is on the passenger side, you have to remove the dashboard.
Remove ALL dashboard screwscarefuly remove the dashboard,andyou will see were the bulbs are located,replace any/and/or/allthe bulbs needed,and reverse theprocedure to reinstall ! That's it !
To remove the dashboard and replace the bulb on a 51 Plate Clio, first remove the two screws on the trim panel. Then remove the instrument cluster and gently pull off the bulb. Replace with new.?æ?æ
The 2003 Mercedes-Benz dashboard has four screws to hold it in place. Remove the screws and the dashboard will come off.
you have to remove the cover of the dashboard to replace the light bulbs
Remove the instrument cluster then replace the bulbs. = =
remove dashboard and replace 2 bulbs behind it
To replace the blower motor on a C230 compressor of a Mercedes Benz, remove the bolts holding the motor in place. It is next to the blower, under the passenger side of the dashboard. Replace with new and reinstall the bolts.
remove the entire dashboard.
To replace the dashboard lights on the 1997 F-150, you will first need to remove the dash bezel and dash cover in order to access the lights. Then, remove the instrument panel cover below the bezel and remove the burned out lights. Replace the lights and add the cover, dash cover, and bezel back to the dashboard.
To remove and replace the heater core on the 1987 Nissan 300ZX with air, begin by removing the dashboard totally. This means the radio panel and the instrument cluster. Remove all air ducts and access the heater core. Remove the bolts holding the core and replace it with a new core. Then replace the dashboard and instrument panel.
how to remove and replace broken antenna on a 2003 Saturn ion
underneath the dashboard on the passenger side.
Open the passenger door & remove the cover on the side of the dashboard...
how do I remove the dashboard from a Mercedes c 280 1995?
remove the dashboard, and u will see the lights behind it
On the passenger side of the dashboard there is a fusebox, open the passenger door and remove the fuse box cover on the side of the dashboard. There is one single screw that you need to take out, and the rest of the dashboard pulls straight out. Then locate your radio and take out the couple of screws. Pull out wiring harness off the back of your radio and it will come out.
How do I remove the dashboard.
Unfortunately you will have to remove the engine to get at it.
Remove the dashboard instrument cluster cover. The cover is secured with four retaining screws. Take hold of the dashboard light, push in and turn at the same time to remove it. Reverse the process to install the new dashboard light.
Set off the airbag. Why would you want to do this?
Adjust steering wheel outward and down to access the dashboard easier. Then with a special removal tool reach behind the side and back. Slowly lift out. The lights are located directly in back of dashboard. Replace them with new lights and return dashboard.
Remove the inside door panel of your 1993 Chevrolet Lumina. Remove the passenger mirror wiring harness. Remove the passenger mirror retaining bolts. Reverse the process to install the new passenger mirror.
To replace the radio on a Ford E350, first remove the bezel from around the existing radio. Then, release the clips on either side of the radio and remove it from the dashboard. Then, release the wiring. Place the new wiring on the replacement radio and insert it into the dashboard. Lock the clips in place and replace the bezel.