most original equipment sound systems have an anti-theft device built into them.
If the power has been disconnected, they need a code entered for them to work again. Contact suzuki dealer and ask for a default code. They will not give it to you over the phone, you may have to verify ownership.
remove plastic cover that dohc 24 valves and that big black mess going from front to back of motor is the intake
There is a card in the glove box with the code or remove the radio and with serial number and vin call the dealer
its on front of head drivers side of car just under edge of plastic intake remove bolt from it and pull out of head
there is not one,the car has to be jacked up on a lift and remove a service plug to check the fluid and it also takes a special type of fluid known as ZF fluid
First get a repair mnl then draw a map of the belt routing. You need a belt tensioner tool to start with. You need to remove some of the tanks on that side of the motor.
3 BOLTS AND TWO PLUGS AND THE HEADLAMP ASSY COMES OF THE CAR. THEN OPEN THE BACK PF THE LAMP AND REMOVE THE BULB JUST LIKE THE OWNERS MANL SHOWS.
how to remove the hood of soft top grand vitara suzuki
how do you remove rear brake drum on a suzuki 2004 xl7
How do I remove the dash on a 2004 Suzuki Grand Vitara 4wd to get to the radio wires?
there are two on back side of motor under intake very difficult to remove and very costly to buy about two grand each and are warrantied to 80,000 miles . take to dealership first to see if has had latest computer flash done.
To remove the driver's seat on a 2007 Suzuki 800c Intruder you need to remove the headrest and remove the screws. Next, remove the bolts and washer on each side of the front of the driver seat.
If it is the same plug every time, I would say the plug or wire is grounding out some where. Try replacing the plug the the wire.