answersLogoWhite

0


Best Answer

I have asked this question to many stereo installation shops, and the answers have been the same. Most shops are reluctant to accept this type of job. The problem is the upper plastic roof panel has small tabs that hold it in place. Over time, these tabs become brittle and break during removal.

First you will need to remove the rear seat.

Next you will need to remove the upper plastic roof panel (above the rear window), being careful not to break the tabs I mentioned earlier.

You should be able to access the top of the plastic side panels the hold the speakers.

User Avatar

Wiki User

12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you remove the rear panel in a 1997 GMC Sierra 1500 to access the 4x6 speakers?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Remove door speakers on 1992 Bonneville?

you have to remove the whole door panel in order to gain access to the factory speakers in which should be 4x6.


How do you change the door speakers of a Lincoln mk vIII?

Remove the door panel and then you get access to the speaker


Front speakers bad on 2006 silverado do you have to remove door panel to fix or change speakers if so how thank you?

Yes the door panel must be removed to gain access to the speakers. Just replace them It will sound better.


How do you remove the interior left door panel on a 1995 GMC sierra?

How do I remove the left side door panel of a 1995 Gmc Sierra without breaking the door panel?


How do you access speakers on 2000 Malibu?

To access the speakers on a 2000 Malibu, you will need to remove the door panel. You also may need tools like screwdrivers and a wire cutter to take the door panel off. Before starting any removal of the panel, you should disconnect the negative battery cable.


How do you replace the front speakers on a 1992 Buick road master?

Front speakers are in the door. remove screws on the door panel, then remove the panel and you'll see the speaker


Must the door panel be removed to install new speakers in a 1994 Toyota Supra?

If the speakers are in the door panel then you must remove the door panel to install new speakers. You can only bypass removing the door panel if the speakers are located elsewhere.


How do you replace the dash speakers in a 1998 Chrysler Cirrus?

Remove center stack bezel (radio, heater control), remove screws from instrument trim panel at ctr stack and remove instrument trim panel, remove dash top panel, replace speakers.


How do you replace 1995 Jaguar XJ6 front door speakers?

you have to remove the door panel. (See here for help:How_do_you_remove_the_door_panel_on_the_1996_XJ6_to_get_to_the_speakers)Then remove the 2 wire harnesses and take off all the screws on the back of the interior door panel. this will allow access to the 6.5 in speakers. good luck. Mine went fairly easy.


How do you get to the rear speakers in 1991 GMC sierra?

fold back seat down, take ashtrays out of rear arm rests, remove the screws holding down the top of the arm rests, remove arm rests, remove plastic panel below the back window, above the back seat, same thing to the plastic panel above the rear window, remove screws holding in side panels, and pry them away from the side of the truck, provides access to rear speakers. DO NOT attempt to remove the side panels, as this requires unfastening the seatbelt mounts, as well as removal of the back seat.


How do you change the speakers on a 1999 Hyundai Elantra?

FRONT SPEAKERS 1.Remove the front door trim panel 2.Remove the speaker retaining bolts,Disconnect the electrical connector and remove the speaker from the vehicle 3.Installation is reverse of removal REAR SPEAKERS 1.On sedan models,the rear speakers are under the package shelf behind the rear seat,remove the seats and high mounted stop light,then detach the package tray panel for access to the mounting screws.On station wagon models,the rear speakers are in the cargo area.Remove the screws,detach the covers from the speakers for access to the mounting screws. 2.Remove the speaker retaining screws.Disconnect the electrical connector and remove the speaker from the vehicle 3.Installation is the reverse of removal


How do you remove the interior door panel of a 1996 GM Sierra Truck?

you take it off, by taking it off how do you remove window hardware from panel?