you have to take off all the trim starting from the piece in the boot against the rear of the car. For each piece, take out all the screws and then pull (there will be some force required because there are also plastic clips holding these in that pull out). If the piece isn't budging, you're probably missing a screw.
Once the trim is gone, I think you have to drill out the places where the speaker is held into the frame. Either that or they screw out...
2004 Toyota celica stereo diagram
5x100
use a flat screw driver.
The pcv valve should be located on top of the valve cover. It plugs in, and should pull out with some gentle coaxing.
How i remove eveporator unit from toyota corolla 2002
twist it HARD
Pulstar Iridium Pulse Plug
Try e-Bay. I've seen them in there.
they are 6x9 speakers
it takes 5 quarts. the same amount for any small engine car. be sure to remove and drain the filter during this process and to install a new one. well that's a load of crap^^My 2002 Toyota Celica GT takes only 3.7 USQuarts.
REMOVE SQUARE PLASTIC PLATE(I USED A STANLEY BLADE)TO REVEAL 4 XPLY SCREWS ,NO NEED TO REMOVE JUST SLACKEN THEM AND PULL MIRROR YOURS T,C U/K
its part of the mass airflow sensor bolted to the airbox.