open you tailgate and there should be 2 screws with hex heads take those out and it should pop straight out
Remove the headlight assembly to gain access to the bulbs.
Open tailgate, remove two small torx screws in side, pull tail light assembly from mounting, screw lamp from assembly and replace defective bulb. Reverse proceedure, voila.
open tailgate, use #2 Philips scredriver and remove the 2 screws that hold the light assembly in, carefully remove light from box corner, unplug main harners from light, unscrew the circuit board on the back of the light remove and turn over, replace bulb and reinstall.
First, raise and support the vehicle. Then remove the wheel and the tire assembly. Also remove the caliper from the steering knuckle, and then remove the caliper adapter assembly.
use the special tool for that
Lower the tailgate. Remove the two screws on the inside to the side of the lamp assembly with an torx wrench. The tail lamp assembly will pop out. Remove the four screws on the backside of the tail lamp with a Phillips head screwdriver. You now have access to the bulbs.
Remove wheelsRemove caliper mounting boltsSilide caliper off rotorRotor should slide of hub assembly
To remove the lens assembly from the truck body, here you go.Open your tailgate, and look at the joining wall of the inner body. There will be two black star head bolts. use an Allen wrench or star wrench to remove the screws. The assembly will be loose, but may not be able to be pulled away. To release the outer side of the assembly, insert a flat blade screwdriver or putty knife at the corners, and pull outward. The outer part is held by two nubs inside of rubber grommets. The assembly will pull away, and will provide you access to the bulbs to change, or to replace your assembly.
After the 2 screws, you just grip and rip. There are plastic clips on the other side that will disengauge.
You will have to remove the entire door panel to get at the screws that hold the handle assembly to the panel.
Lower the tailgait and locate the two Torx screws that hold the light assembly. Remove the two screws with a T25 and pull the light assy straight out. There are two friction locks that should release easily. Rotate the bulb holder 1/4 turn ccw to access the bulb. See sources and related links below for bulb information.
remove fuel tank after draining. remove all lines hoses and wires from top of tank. remove fuel pump assembly by turning large plactic nut counterclockwise. disconnect wires inside pump assembly. slide senor and float from fuel pump assembly.