Want this question answered?
How to Reset Maintenance Warning Light on a 2008 Toyota 4Runner
There's a Phillips screw at the top of the marker light. You would need to unscrew that and then you will be able to remove the side marker light from your Toyota 4Runner. We have also included a link to a video in the related links section below.
Look in the trunk, there is a cover over the light assembly - open and you will have access to change the light.
Open trunk and remove screws that secure light assembly to car. Pull assembly straight back to remove from car. Remove the dead light and replace with proper new light. Install in reverse order of removal.
Question isn't clear. Are you asking how do you replace the bulb -OR- how to remove the entire lens assembly?
It's removed from inside the rear compartment. Open the rear hatch and on the inside of the light you will find a snap-off cover. open it and remove the light assembly with a 1/4 turn. The bulb assembly should pop out
Open the trunk; Remove the trunk liner; Remove the bulbs/wiring; locate the bolts securing the tail light assembly to the body; Remove the nuts; lift the assembly away. Cheers
Open the tailgate and look between the tail light assembly and the tailgates weather striping. You will see two galvanized Phillips head screws. Remove them and pull outward and the tail light unit will pop out. The bulbs are screwed into the back of the tail light assembly.
Phillips screwdriver...two screws throught the lens. Remove the lens and extract the lamp. It pulls out.
Check your maintenance manual. It's in there.
have you tried pulling the EFI fuse
On a 2012 toyota Highlander, How do you replace tail light Assembly