jack up front of vehicle and support proprely.remove r/f wheel and rubber dirt shield.this opening in the wheel well will be big enough to remove starter after disconecting.
The starter is located on the driver side of the under the intake maniford it has two bolts 14mm to remove it.
it is under the intake manifold. very hard to see and no fun to remove.
replaceing windshield wipers toyota truck
it is right over or under the starter on the passenger side, take off the passenger side wheel and it will be easier to see
it is right over or under the starter on the passenger side, take off the passenger side wheel and it will be easier to see
5.5 LITRES
get a rebuilt you will be better off
The starter for your 1992 is located behind your passenger side wheel well. Remove tire and you will see a panel at the top of the wheel well remove it and the starter is behind that.
disconnect negative cable from battery ,raise vehicle in air place securley on jackstands,disconnect the leads from the starter,there should be one clip connection and oneterminal held on by a nut and washer,remove the bolts retaining the starter to the bellhousing remove the starter,sometimes it may be required to loosen the exhaust to have enough clearance to remove the starter ,but not always,toreplace starter just reverse the removal procedures.
The exhaust manifold
type your answer here...
Remove the cables from the starter. Tape the end of the positive cable, so it will not spark. Remove the retaining bolts from the starter. Reverse the process to install the new starter.