Want this question answered?
Open the tailgate, remove the retaining cables from the studs, pull out on the passenger side of the tailgate.
big hammer
Why is the water not circulating in my 1995 C1500 Chevy truck?
Remove the tire and wheel from your 1995 Chevy. Remove the brake assembly. Tap on the brake rotor with a mallet or hammer. The brake rotor will slide off.
open tailgate. unclip the cables that hold tailgate level they will unclip from the top anchor post without using any tools.then lift tailgate from left side so as tailgate hinge comes up from pivot point. then slide tailgate little to the left and you should have tailgate in your hands
On the inside of the tailgate are two bolts. remove them and the taillight will fall out. If you have a bed liner you might have to take it out. On the inside of the tailgate are two bolts. remove them and the taillight will fall out. If you have a bed liner you might have to take it out.
You cannot remove what is does not have. There is no governor on the vehicle. The engine revolutions and speed are controlled by the ECU and you cannot remove that nor reprogram it unless you are a techno whiz.
It has the 4L60E transmission in it.
To remove the tailgate lock on a 1989 S-10 Blazer, first remove the cover over the inside of the tailgate by removing the bolts on the side and on the handle. Pop the vinyl away from the tailgate. Then remove the bolts holding the lock on and remove the lock.
2 screws on outside edge and 2 screws on inside(undo tailgate)
cant open tailgate
First you need to remove the trim bezel around the handle on the outside of the tailgate. Then remove the three bolts on the inside of the tailgate,that hold the handle in place. Next remove the latching mechanism rods from the handle,and remove the handle from the tailgate.