Want this question answered?
You don't have to remove wiper arm. The wiper blade will slide out, It has a clicker in the center of the blade that you have to slide it out. Look at it very carefully
The Toyota Highlander rear wiper blade is held in place by two retaining clips. Remove the retaining clips and the wiper blade will slide out.
pull off the wiper blade with and outward motion with your arm and slam the new set of wiper blades back on
Assuming that you mean "wiper blade" (blade and frame) which are replaced often rather than "wiper arm" (piece from the spindle at the hood to the wiper blade) which are rarely ever replaced, the 2001 Toyota 4Runner has the most common hook-end wiper arms. See sources and related links below for installation videos. Also, purchase the replacement blades first and there will be additional instructions/illustrations on the replacement packages. Locate and press the tab or button where the wiper blade is inserted into the hook of the wiper arm and pull wiper blade out of hook. You may have to rotate and flex the blade to make enough clearance for the hook to pass through.
The 2001-2009 Mazda Tribute takes a 10" or 11" rear wiper blade.
Assuming that you mean "wiper blade" (blade and frame) which are replaced often rather than "wiper arm" (piece from the spindle at the hood to the wiper blade) which are rarely ever replaced, the 2001 Oldsmobile Bravada has the most common hook-end wiper arms. See sources and related links below for installation videos. Also, purchase the replacement blades first and there will be additional instructions/illustrations on the replacement packages. Locate and press the tab or button where the wiper blade is inserted into the hook of the wiper arm and pull wiper blade out of hook. You may have to rotate and flex the blade to make enough clearance for the hook to pass through.
How do you remove the wiper arms on 2001 Lincoln LS
The 2001-2006 Acura MDX's have a proprietary rear wiper and you must either go to the dealer for a replacement wiper blade or you can buy aftermarket "refill inserts" which is just the rubber blade rather than the entire wiper blade and frame.
how do you replace a wiper motor in a 2000 jetta?
Since rear wiper blades undergo substantial abuse - especially in icy/snowy locations - and most vehicle owners do not replace the rear wiper very often, I highly recommend replacing the entire wiper blade assembly (blade and frame) vs. (rubber wiper refill blade). It is only a few dollars difference.Be sure you get the correct-fitting replacement wiper blade. The 2001-2007 Chrysler Town & Country Van takes a fairly standard 16" rear wiper blade and installs similar to the front wiper blades.
1.Lift the arm assembly away from the glass for clearance.Press in on the lock tab and push the blade assembly down the wiper arm out of the hook at the end.Squeeze the blade element tabs tightly and pull the element out of the metal frame.
PULL THE WIPER UP, HAVE THE WIPER BLADE/ ARM HORIZONTAL, PUSH THE TAB THAT'S UNDERNEATH THE CENTER THE BLADE/ARM THAT'S ATTACHED TO THE MAIN ARM, THEN PULL THE BLADE/ARM DOWN. IT SHOULD DETACH FROM THE MAIN ARM AND LEAVE A "U" ATTACHEMENT EXPOSED.