Want this question answered?
how do you bleed the clutch master cylinder in a 2005 mazda 3
Yes there is a hydraulic clutch on the miata. Just to the outside of the firewall, near the brake master cylinder is the clutch master cylinder and resevoir.
the clutch and the brakes share the same master cylinder on my 1991 protege dx 1.8 sohc
First you need to find out if your slave cylinder is leaking clutch fliud.check lines to slave cylinder from master clutch cylinder if no leaks most likely master clutch cylinder bad.
No fluid in the master cylinder
no it is hydraulic.dont know what your problem is but check clutch master cylinder and slave cylinder operation,if ok may just be a bad clutch
Check for bad clutch master cylinder or slave cylinder.
there is no clutch cable. it has a hydraulic clutch. there will be a clutch master cylinder on the firewall near the brake M/C. a hydraulic hose will connect that to the clutch slave cylinder on or near the tranny. the slave cylinder pushes on a fork (lever) that disengages the clutch.
there is no cable, it is a hydraulic system and you probably just need a new slave cylinder or a master cylinder. Both are easy to replace. it could be that you just need fluid in the resovior.....
Clutch master cylinder might be blown out. this is located in the engine bay, the top right.
About 1 hour.
The clutch slave cylinder on a 91 Mazda 626 DX is located on the clutch bell housing. To replace the unit, first remove the hydraulic line and turn the line cap counterclockwise. Remove the two bolts holding the slave cylinder in place. Reverse directions to install new unit.