0
How do you replace a crankshaft sensor on a 1996 Legacy Subaru?
Wiki User
∙ 18y ago
its right in the front middle of the engine/ unscrew the bolt and pull it strait up/ if it gets stuck in the hole you will have to use a drill and carefully poke holes in it and brake it apart then pull it out
Wiki User
∙ 18y ago
Add your answer:
Earn +20 pts
What is the ignition timing supposed for a 2.2L 1993 subaru legacy?
The 1993 Subaru Legacy 2.2 liter engine ignition timing is the sequence that allows the engine to run smoothly. The ignition timing is synchronized with the crankshaft position sensor.
How do you replace crankshaft sensor?
how to replace crankshaft sensor on Corsa 1-2 2002 .Which parts require removing to replace unit
How do you replace o2 sensor on 1998 subaru legacy?
Use a 7/8" O2S wrench, socket, or crow's foot to unscrew the sensor, then put a new one in.
Where is the MAT sensor on a 95 Subaru legacy?
Unsure where you'll find the bugger, get your auto sparky to replace it (its a MAP sensor) as it can cause real headaches if it dies, engine rebuilds and such
How do you replace the engine coolant temperature sensor on 1997 subaru legacy?
You could look here:http://www.lovehorsepower.com/SubaruDocs/CoolantTempSensor.htmlThis page shows the coolant sensor and how to replace it.'95 Subbie and '97 should be similar.
Could the mechanic damage the crankshaft sensor while replacing the timing belt and pulley?
I had the timing belt on a 2001 Subaru Legacy replaced. After getting the car back, it was misfiring, and eventually the engine shut down. Dealer diagnosed faulty crankshaft sensor. Anybody else have this experience?
How many wires on a after cat O2 sensor subaru legacy?
four4
Where is the speed sensor on a 91 subaru legacy?
In a 1991 Subaru Legacy, the speed sensors can be found on the driver's side of the transmission. They are located towards the rear, and there are three of them.
Where is the o2 sensor on a 1997 subaru legacy gt 2.5?
Under the sea.
Where is the knock sensor location on a 1998 subaru legacy?
In a 1998 Subaru Legacy, the knock sensor is located on the top of the engine block and to the left of the engine. More specifically, it is under the left rear intake manifold runner.
After replacement of crankshaft sensor Nissan engine light still on. Is this ok?
i have replace the crankshaft sensor but the code cannot be erased
How do you replace crankshaft sensor on a VW jetta 2.5l 2006?
where is the crankshaft position sensor on 2.5 liter vw jetta
