Open the cover of the boot lid - from there on you should see the bulb socket ==New Answer Headline== Have just figured out how to replace a bulb in the license plate light of my 1999 S40. Not sure if it is exactly the same as the 2000 model but here goes. Open back the trim on inside of boot lid so that the two license plate lights are visible. (They are located on either side of the boot lock). Locate the two wires that are connected to the bulb holder which projects from the back of the light. On my S40, the bulb holder is black and conical and appears to be an integral part of the light assembly but can be removed by squeezing either side and pulling directly back out of the light assembly. To make removal of the bulb holder easier, you can first disconnect the two wires from each holder. As you remove the bulb holder, be careful not to drop the holder and bulb into the sapce between the reinforcing metalwork on the inside of the boot! Remove old bulb, and fit new one into bulb holder, push holder into back of light assembly and check that it works before replacing into back of light assembly and replacing boot trim! If for some reason you need to repalce the entire light assembly, first remove the external panel that contains the boot lock and runs along over the license plate. Do this by unscrewing the four nuts on inside of boot lid that hold panel in place. Light assembly can then be removed by pushing from inside to outside after pressing on internal plastic retainers that are part of light assembly.
It is very easy to change the license plate bulb in a 2001 Dodge Intrepid. You will need to remove the tag and then unscrew the light cover. After the cover is off, unscrew the light and replace with a new one.
The 2001 Toyota Camry license plate light fuse can be found in the fuse box. The license plate fuse will be labeled as the tail light fuse.
how do you replace the bulb of a volvo v70xc 2001 side mirror?
The 2001 Ford Focus Owner Guide shows : ( C-5W , license plate lamp )
On top of the license plate is a clear plastic lens with 2 screws in it. Take it off. Then a bulb slides into the holder, then replace the lens. There are 2 bulbs. One on each side.
License Plate Light Bulb Size: 6418
Yes, all cars have a license plate light. It is mandated by law.
sledghammer
on the 2001 XZ3 I removed the license plate and used a flat head screw driver to slid the license plate light cover over and they "pop" out.
For the rear plate yes, but not the front one.
Pry down the metal clip on the top with small screwdriver, then pull screwdriver forward. Assembly will come out easily from there. Small bulb to replace.
== == This is a link to the 2001 Volvo S40 Operation and Care Manual: http://new.volvocars.com/ownersdocs/2001/2001_SV40/01sv40_06b.htm#pg94 It may require you to register.