For a Galant:
Open the trunk. Remove the three clips. Take off the trim cover partially. Remove the three light case mounting nuts. Push the white square grommet and remove the light case. Remove the socket assembly and bulb together by turning it counterclockwise. Take off the bulb by turning it counterclockwise while pushing it inward. The outer two bulbs are for the tail light. Use bulb number 2057.
You can not, you will have to replace the entire tail light.
Take 2 screws out and pull light straight back, it will come over, replace bulbs and put back on and replace screws
to replace the tail light open the hatch look on the side of the light you will see two screws remove them. Pull the light out, take the three bulb out ken
you don't replace the tail light you just replace the bulb in it
Assuming it is the same as a '99 Galant: you go into the trunk and unscrew the three plastic caps that are holding the fabric-covered partition on on the side of the tail light that needs the new bulb. Then, undo the nuts holding the bolts on. There is a plastic-covered bolt there - push on that and it pushes the entire tail light assembly out. Then, undo the bulb holder and replace the bulb.
to replace tail light lens on a ford pickup. lower tailgate on side of bed that is hidden when tailgate is closed, you will see 2 screws. remove these screws and you can pull tail light out of bed.
well its easy look up your bum ya monkey!
Forget it. I figured it out.
The fuses on the 2000 Dodge Durango should be labeled for each part such as the tail lights. The tail light fuse is a 30 A.
In order to replace the rear window tail light you need to get into the truck. Once inside the trunk look to the top of the trunk and look at where the screws are for the rear tail light. Unscrew them and the entire housing for the light will pop off.
On a 2012 toyota Highlander, How do you replace tail light Assembly
To replace the tail light bulbs in a 2000 Dakota open the tail gate. You will find two screws on each side that hold the tail light assembly in place. Unscrew these two screws then pull the assembly straight back. There are two pins holding the assembly so do not pull to the side they must come straight back.
Replace it with a new one.
Phone your local Mitsubishi dealer
The 2002 Mitsubishi Gallant tail light fuse is located in the first column of the fuse box. The tail light relay switch is also in the fuse box, at the top of the third column.
you can take the tail light out by unscrewing the wing nuts in the trunk, when all wing nuts are off pull the tail light out then take the light bulbs out to replace the tail light.
Remove tail light housing. Remove lamp. Replace lamp. Replace tail light housing.
peel off carpeting behind the tail light from the trunk. there should be bulb holders- pull out the holder that holds the busted bulb. you can do this by slightly turning it and pulling it out. change the bulb and replace the holder the same way you removed it.
You open the trunk and remove the plastic wingnut screw on the backside of the tail light and replace the bulb and put the nut back on...very easily done without tools...
Under the dash is a fuse block and in the fuse block there will be a burnt fuse. Replace it with a new one.
from inside the trunk just take the plastic pins out that hold the carpet directly behind the tail light and twist the light socket out and change the bulb
How do you replace a broken tail light cover for a 2005 Nissan Pathfinder ?
Have a look at this link: http://www.wikihow.com/Replace-a-Tail-Light-on-a-Dodge-Grand-Caravan
the tail light is screwed in from the inside of the bed of the truck