How do you replace fuel pump 92 Mazda pick up B2200?
The Mazda B2200 truck body did not change much, if at all between 1986 and 1993. There should be no differences in the shape of the engine compartment. -Kyrasis6 Owner of Mazdatruckin.com
Yes you can. Virtually any engine can be turbocharged.
turn your steering wheel all the way to the left, get your 10mm socket with 1/4" ratchet wobble and 2x 2" extensions and remove the several bolts holding the dust cover from inside the wheel arch. Then proceed to remove the existing broken antenna (you will need to reach up into the guard to hold the antenna) and using a 14mm ring spanner undo the topmount fitting on old antenna, Then Reverse (the antenna cable goes through the side behind glove box just trace it and replace that with new cable that comes with new antenna) or you could just cut and solder the old cable to new antenna.
Gap is 0.031 or 31thousandths. your truck has the 2184 cubic inch engine.
I have a 88 B2200 and i did a 318 V8 swap. Wasnt hard. Added coils to front. Welded in the mounts and changed nothing else. Fast but managable.
Is very possible but it is a wate of time and money, I have B2200 and trust me the smallest engine that can manage the weight of that mini pick up is a 2.0L anything smaller is a waste, I tried with RX7 engine and it is not that reliable, unless is turbo and have to play with diferential ratios
It is located under the thermostat housing with a single wire connection.And the upper radiator hose goes to the thermostat housing.
Ummm no where??!!?! for one a b2200 is a Mazda pick up and in that case it would be on the drivers side half way back affixed to the inner side of the frame rail :P simalair location on either truck though
The schematic diagram of the fuel injection system of a 1992 Mazda B220 can be seen in the service manual of the said model. This can be acquired by contacting the vehicle manufacturer or service centers.
Well on my 1987 it is stamped on the driver side frame rail (with the left front wheel removed) you can see the serial numbers stamped into the metal at the curveature behind the shock going toward the fender weld.Should be the same for your model.Easy.
It has bristles or sensers on the antenna. It depends on what bug.