0
Your question needs some clarification. If you meant to say how do you replace the front/rear flexible brake hoses (assuming you have rear disc) or how do you replace all of the brake lines on my Accord that would greatly help direct a more direct response.
You should have specific hand tool before changing your brake lines, and that is a flare nut wrench. I have a 10mm and 12mm flare nut wrench that works well. This wrench if thicker than a standard wrench and one side is approximately 75% closed (like a box end wrench) to allow for more contact area and reduce stripping the flare nut.
There are also clips that hold the line to a bracket where the 'hard' & 'flexible' lines connect. Leave this in-place until you have loosened the connector (and install the clip) before you tighten the connector
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Brakes are very soft replaced master cylinder and bled did not help what to do next 1996 Honda accord?
Bleed em again. Then replace the brake lines. Which would involve more bleeding.
How do you Replace the left cv joint on a 1989 Honda Accord?
The left CV joint can be replaced on a 1989 Honda Accord by removing the left tire and the moving the brake lines. Next, the ball joint and the tie rod should be removed, which will allow for their to be enough room to use a pry bar against the transmission which will pop out the CV joint.
Do you remove tires to replace brake lines?
You remove the wheels to replace brake lines.
What controls the vacuum lines in a 93 Honda accord?
The vacuum lines, in a 1993 Honda accord, are controlled by a vacuum pump. The vacuum pump regulates the proper pressure in the vacuum lines.
Can you use rubber fuel lines to replace your brake lines?
You can not use rubber fuel lines to replace the current brake lines due to the high operating pressure. You will need to replace them with brake lines, the rubber brake lines has a different construction to hold the pressure and not getting eaten away by the brake fluid, brake lines can hold over 2000psi when the pedal is heavily applied
How do you replace the brake line on a grand am?
How do i replace brake lines on a 2000 grand am
How do you replace the brake booster on a 1990 Honda civic?
The brake booster on a 1990 Honda Civic is held in place with several mounting bolts and the brake master cylinder. Remove all the mounting bolts, vacuum lines and the master cylinder. Go underneath the dash and remove the plunger from the brake pedal. The booster will fall out. Replace the unit.
What is the cost of replacing all of the brake lines on a 1995 Buick Park Ave?
Why would you want to replace all the brake lines? You can flush the entire system and install fresh DOT3 brake fluid. I can see no reason to replace all the brake lines. Why are you doing this? Unless your brake lines are rotted out or someone has cut them... there is no reason to replace all four lines.
Where is the vacuum line in your 1993 accord?
There are several vacuum lines on a 1993 Honda Accord. Each vacuum lines delivers air to different parts of the engine.
How do Honda Accord cars compare to other Honda lines on gas mileage?
The Honda Accord gets good gas mileage. The 2013 model gets 34mpg highway. Other Hondas, such as the Honda Civic, get better gas mileage but the Accord is a very fuel efficient car.
How long does it normally take to replace brake lines on a 1995 Toyota Corolla?
It should only take about an hour to replace the brake lines on a 1995 Toyota Corolla. The exact time will depend on your experience with replacing brake lines.
What does service code B1 mean on a 2006 Civic?
From Honda Accord 2007 Manual - B - replace engine oil and filter inspect brakes check parking brake inspect tie rod ends, steering gear box, boots suspension components driveshaft boots brake hoses and lines +ABS fluid levels and condition exhaust system fuel lines and condition Code 1 means rotate tires
