Go to an auto parts store and get some new ones.
replace it
The brake hose is connected to the caliper with a special hollow bolt. There are also two copper washers used, along with rings on the bolt and the parts, to seal the brake fluid in a high pressure fitting.
There should be a metal washer on both sides of the fitting where the brake hose attaches to the caliper. You may need to replace the washers with new ones to stop the leak.
i have a Pontiac grand am 2002 se and i just changed my brakes and the brake lines have 2 washers on them
How do you replace from brake on Kia Rio2003
How do i replace brake lines on a 2000 grand am
Remove or disconnect the following:Front wheelsFront brake hose bolt and the copper washers and plug the front brake hose2 front disc brake caliper slide pins, then lift the caliper off of the front caliper anchor plateTo install:Install or connect the following: Front disc brake caliper onto the caliper anchor plate. Install the 2 slide pins. Tighten the slider pins/bolts to 21-26 ft. lbs. (28-36 Nm).Front brake hose to the brake caliper, using new copper washers. Tighten the retaining bolt to 26 ft. lbs. (35 Nm) on Excursion models or 23-29 ft. lbs. (30-40 Nm) on all other modelsBleed the brake system.Clean the wheel hub mounting surface.Install the front wheels and snug the lug nuts to fully seat the wheel against the hub.
You remove the wheels to replace brake lines.
There are a number of video tutorials on how to replace a brake caliper at the link below .
how to replace brake fluid on a 1999 Toyota 4runner
To replace your brake light, you need to unscrew the brake cover from the inside of the trunk. Then you will be able to pull the old bulb out and replace it.
no