Replacing the egr valve is quite simple. the line at the bottom of the egr vave needs to be taken off first using an open end wrench.( be careful on this step if the line is broken it can sumtimes get costly) remove the two bolts on each side of the valve then simply swap it out. you might want to replace the gasket while you have it off. make sure when reasemmling it you start the line on the bottom before you but the other two bolts back in.
nope has to be the 32 valve engine
The EGR valve on a 1979 F150 with a 302 is located in the center of the engine. It is close to the firewall.
I would first replace the PCV valve as it may be simply stuck open.
The EGR valve, on a 2004 Ford F150 5.4 liter engine, is located on the top of the engine near the back. The valve is difficult to identify without prior mechanical knowledge.
what carbutor model engine fit in a 1994 ford f150 with a 5.8 lighting engine
The Internet.
The PCV valve on the 4.9L I6 engine is nearly impossible to see. It is located at the top of the valve cover near the rear of the engine forward a few inches from the center of the firewall. It is easier to see and reach it if you use a step stool.
Need more info. Which valve are you referring too?
I have a 2004 Ford truck F150 V8 5.4 L .. do I need to replace the PCV valve that is causing bad back up condensation
a 2 valve engine , the 3 valve 5.4 L is used in 2004 and newer F-150 Ford trucks
you do not need to remove intake manifold to change valve cover gaskets. intake bolts to the block. valve covers bolt to the heads EDIT: Theirs some clearance issues but you can maneuver the valve cover out.
it is part of the egr valve
support engine. unbolt engine mount install new engine mount
Check out the enclosed instruction book.
Sepa la mow.....
where is the pcv valve on a 1992 f150 with 5.0 liter
how to relace a door jamb switch in a 1994 f150
On the throttle body
I'm going to replace the valve cover gaskets on my 5.4. The top bolts their very loose, but hesitant to come out. any thing would help me
The PCV valve on a 1993 F150 is located in the top of the valve cover. it is a plug in type, and is easily replaceable.
The EGR valve is located in the center of the engine on a F150 Lariat 5.4 liter. It is near the firewall.
One the engine block on the 302 and 351's
( .054 inch ) according to www.motorcraft.com
The intake is mounted to the center of the top of the engine, and the pcv valve would probably be on the top of right valve cover, near the back of the engine, underneath the firewall. You got problems already?
a 5.0 is a v8 engine, so there are 8 intake valves.each cylander has 1 intake and one exhaust valve in the head. to install a valve the head must be removed from the engine block