Yes, I did it. It's very tricky but I did it. If you still don't quite understand the way I explain it, send me a email at mac.mailer@Yahoo.ca and I can send you the diagram.
You need to prepare with 2 flat end screw drivers. Firstly, undo the 2 or 3 screws of the metal cover which covers the two plastic lenses with a philips screw driver. Now, the two plastic lens covers are infront of you. Take one of the flat end screw drivers pry from the top of the lens cover which you want to place the light bulb. You have to pry it as hard as you almost break it then you'll see either on the far left or far right of the lens (depends on which side you pry the lens on) has a little plastic piece (which is a snap reverse hook for the lens to snap in tight when they first install the lens). Now, you use the second flat end screw driver to push the little plastic piece towards the center of the lens housing, then the lens will pop out of the hole. You can now replace the bulb and then pop the whole thing back in. You don't need to go to the service man or the dealership to pay them to replace a simple license plate light bulb. I found Mercedes's design is great, but it can also be a real pain in the a.. to have the simple thing done by the owner. Send me a email if you still need the diagram. Good luck.
how do u change the license plate light on a 2005 sienna
how do you replace license pate light on 2006 pontia g6
Unscrew license plate and remove to expose light fixtures. Wedge light module away from holes. Replace them and return them to sockets.
It is very easy to change the license plate light on an Oldsmobile Aurora. All you need to do is remove the license plate and look above where the plate was. There are bolts that are holding the light in. Unscrew the bolts and then replace the light.
How do you change the liscence plate light fuse
They are located inside the trunk lid, underneath the felt lining. You need to unsnap and pull back the felt lining to access the bulbs for the license plate light.
Raise the trunk lid...you will see the lights on each side of the license plate...use Phillips screw driver to remove and replace bulb. Just did this takes about 2 minutes.
Remove the screws from the lens covering the bulb, pull out the bulb and replace it.
Superdiscount LEDs has a tutorial out how to change the license plate light to an LED light. Its pretty general how to do but a lot easier with pictures. Heres to step by step links that should help you! http://www.superdiscountleds-how-to-install-leds.webs.com/ -OR- http://www.go-audi.com/14083-audi-q5-how-do-i-replace-license-plate-bulbs.html Source: www.superdiscountleds.com
there are two spots above the license plate where the lights go on each one there should be a spot where you can push the cover in and then just pull out at an angle
They are located inside the trunk lid, underneath the felt lining. You need to unsnap and pull back the felt lining to access the bulbs for the license plate light.
To change the license plate light on a 2002 Geo Tracker, remove the light lens with a small screwdriver. Take out the old bulb and replace with a new one. Tighten the screws on the light lens.