answersLogoWhite

0

How do you replace pickup coil gm?

Updated: 12/6/2022
User Avatar

Wiki User

16y ago

Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: How do you replace pickup coil gm?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you replace the tailgate cables on a 2002 Chevy S-10 pickup?

You are in luck. GM has a recall on these cables and will replace them for free. Contact your local GM dealer.


How do you replace the evaporator coil on a 1995 s10 Chevy pickup?

take to your chevrolet dealer


Will a stock GM 6-cylinder hei distributor work in a GM 8cyl by only changing caps?

No, the coil is in the cap on a HEI distributor also there will be 6 pickup elements instead of 8


How do you change a pickup destributor?

you must remove the distributor, disassemble unit and replace pick up coil


How do you change pickup coil on 1978 Chevy pickup?

u have to pull the whole distributer to change the pickup coil


How do you replace a pickup coil on a 1982 seca 650?

Get a Haynes Manual for the bike. Go to www.xjbikes.com for further assistance.


How do you replace the ignition in a 2001 Pontiac Grand Am?

ignition what? coil, swicth,module, lock cylinder? gm Jim


How many coils or spark on a 1992 Chevy 305 4x4 pickup replaced cap and pickup coil still no spark?

I would replace the ignition module in the distributor.


What are symptoms of a bad pickup in the distributor?

it does not run smoothly and not all plugs fire when supposed to Addition to above: No spark or intermittent spark, a problem that was fairly common back when distributors had vacuum advances was that one of the wires going to the pickup coil (pole piece) would break from the back and forth movement of the pickup as the vacuum advance would move it to control the timing, symptoms would be no start or that it would start and when you put a load on the engine and the vacuum dropped the vacuum advance would start to move the pickup coil, the broken wire would open the circuit and the spark would die.To check this problem was fairly simple by removing the cap & rotor and tugging lightly on the wires where they go into the pickup coil/pole piece, if one of the wires was broken you could see it and knew you had to replace the pickup coil which GM called a pole piece (magnetic pickup coil and pole piece are the same thing).


I have a 1996 Chevy Tahoe - When it rains the SUV will not start What could cause this?

You need to replace the Distributor cap with a factory GM cap. be sure to check the coil wire where it goes into the coil, pull it out and it should be shiney on the end. If not replace coil and wire too. That will fix it.


How voltage is induced in a permanent magnet pickup coil as the reluctor approaches alignment with the pickup coil.?

The Hall effect.


How do you replace the ignition module on a 1976 Chevrolet Cheyenne?

The pickup coil in the distributor? !976 should be an HEI distributor. Take the cap off, unplug the wires going to the distributor, remove the rotor and the pickup coil is under the rotor and held in place with two screws.