answersLogoWhite

0


Best Answer

Remove the tire then remove the brake caliper take the pads off and replace them just like you removed them. Put the brake caliper back on you will need to bleed the brake line on the caliper add brake fluid if needed and put the tire bak on.

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you replace rear disk brakes on a 2001 Ford F-150 2WD?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you change the battery on a 2001 Ford F150?

How do you remove and replace the battery on a 2001 Ford F150?


How do you replace a fuel sending unit on a 2001 ford f150?

Chainsaw


How do you replace tail gate latch for a 2001 ford 150?

How do you replace the tail gate latch on a Ford f150


How do you replace the alternator on a 2001 Ford F-150?

how to install alternator2001ford f150


Is the transmission on your 2001 Ford Escape bad?

I have a 2004 and have had to replace transmission, and replace brakes a lot


Ford F150 Brakes?

form_title= Ford F150 Brakes form_header= Drive safely with new brakes. When was the last time your brakes have been replaced?*= _ [50] Have you noticed any issues?*= () Yes () No Do you have to press hard on the brakes?*= () Yes () No


Will 2001 ford f150 drivers door fit on 2001 expedition?

Yes, the 2001 Ford F150 driver's door will fit on the 2001 Ford Expedition.


How do you replace ignition coils 2001 ford f150?

take off the distributor cap see what you find.


What is top speed of 2001 Ford F150?

The top speed of the 2001 Ford F150 top speed can be from 105 mph to 155mph.


Where are the bleeder screws for brakes on ford f150?

Disc brakes at the top of the caliper Drum brakes at the top of the wheel cylinder


2001 ford f150 front brakes making clicking noise after changing pads and rotors. what could be wrong?

Anti-rattle clips not installed properly


How do you replace the antenna on a 2001 Ford F150 Truck?

I had to replace mine after it broke. All I did was remove the OLD stub with a crescent wrench and replace it. It took about 1 minute. That is all you have to do.