The black knobs pop out. Use a flat head screw driver to pry the knobs out, then the bulbs become accessable. The knobs are just as easily replaced, good luck.[This applies to Chrysler's T&C up to the current models]
Open rear hatch, look at tail light lens, there are two screws in it, take them out, the lens will come out, twist the socket to release it replace bulb. I suggest using some dielectric grease in the socket while you are at it, might save trouble down the road. AJ
Sorry, I do not have an answer for you, but I am having the same problem with my 2009 Chrysler Town and Country. 24,000 and I need new brakes. What a joke. This will be the last car I buy from Chrylser.
How do you replace from brake on Kia Rio2003
Vacuum leak? Check valve on power brake booster?
On the wheel cylinder. Assuming you meant brake bleeder.
How do i replace brake lines on a 2000 grand am
You remove the wheels to replace brake lines.
the fuses are located near the pull out emergency brake where your left knee is when sitting in the drivers seat. Usually in a small square box with a flip lid. Good luck.
There are a number of video tutorials on how to replace a brake caliper at the link below .
how to replace brake fluid on a 1999 Toyota 4runner
To replace your brake light, you need to unscrew the brake cover from the inside of the trunk. Then you will be able to pull the old bulb out and replace it.
no