first you have to pull of the door panel after that your should have a pretty good view and your should se the inide of the hndal and there will be like linkage and dissconect it and there shouls be a couple screws take them out slide the new oone in though th front bolt it on put hte likaga back on and it should be good
That's what I am asking you. How do you replace a parking brake handle on an S-10 1996 Chevy Blazer?
Remove the door trim panel. Remove the inside door handle rod. Remove the inside door handle retaining rivets. Remove the inside door handle from the door by sliding the handle rearward.
the door speakers you must remove the door panels to get to them. the whole thing pops off but the door handle has one bolt and you have to take of the window crank (if you dont have automatic windows)
How to Do It - 2012 How to Replace Outside Car Door Handle Toyota 1-10 was released on: USA: 27 May 2013
Should have access after removing inner door panel
You will need to remove the inside door panel of your 1988 Chevrolet Blazer S 10. Remove the door handle linkage. Remove the door handle retaining bolts. Reverse the process to install the new door handle.
You have to remove the door panel. Start by taking out the screws in handle and opening lever. Then remove U-ring on the window roller handle. Then you have to pull the whole door panel off...be careful not to break too many plastic clips while doing so. You then have access to the mirror!
You need to remove the entire door pannel. There are manuals that show you how to do it.
Go to a junkyard and buy an entire door, they are fairly cheap.
Are you talking about the 3rd door handle that breaks? I have instructions on how to replace it and how to adjust the door if you are interested. ssbillet@comcast.net let me know.
you will have to replace the handle, the inside door panel has to come off and then you can get to the 10 millimeter bolts that hold the handle on unless it's a 2 door and then your glass will have to be taken out of the regulator and lifted out of the back track to be able to get to the bolts, unhook the plastic clip that holds the handle rod to the latch and take the bolts out and your handle will come out.
Take inner door panel off and the plastic deflector paper and there are 2 10 millimeter bolts that hold the handle on, tighten the bolts and your all set.