We need you to answer this question!
If you know the answer to this question, please register to join our limited beta program and start the conversation right now!
How do you fix or replace a power window cable on drivers side for a 1992 infiniti Q45?
Check out this web site www.cflwindowregulators.comthey can help you.
Asked in Infiniti Q45, How To
How to replace fuel injector for 1992 infiniti q45?
Injectors 1, 2, 4, & 8 (the four corners) are able to be removed without taking off the plenum. Detailed instructions with pictures can be found @ Q45.org. ...
What do you need too replace a starter in a 1992 infiniti q45?
Jack Jack stands Metric Sockets Metric open-end wrenches
Asked in Vehicle Cigarette Lighters
How do you replace the lighter fuse in a 1998 infiniti Q45?
replacement of lighter fuse in a 1998 q45 infiniti
I have bad vibration in rear from 30 mph and up in a 92 infiniti Q45 any ideas?
The driveshaft on the 90-93 Q45 had a thinner rubber bearing than the ones found on the later model years. According to my Q45 specialist, it was a common issue and was usually replaced under warranty. If your Q45 has 100k+ miles on it, I would suspect the driveshaft bearing. Purchasing a factory driveshaft now would most likely get you the later model shaft with the thicker bearing. Another issue could be your transmission mounts and exhaust hangers. The rubber may have...
Why the tail lights and dash lights dont work on a 1992 infiniti q45?
most likely a blown fuse, replace, if it blows again you have a short, if you have a trailer connection look there first ...
Asked in Jeep Wrangler
How do you replace the universal joints on a 1992 Jeep Wrangler with a 4 inch suspension lift?
This is a big job and you can cause your driveshaft to vibrate if you don't do it corretly. I suggest taking it to a garage. ...
1992 infiniti Q45 starts but gas peddle doesn't work?
i have a 1992 q45 and when some work was done at the shop somehow the throttle cable on top of the engine came off track. iput it back on and that fixed it ...
Asked in Chevy Astro
How do you replace a rear you joint in a 1999 Chevy Astro van?
Unbolt/remove driveshaft. Use U-joint press to remove old U-joint, install new and replace driveshaft. ...
Asked in Clutches and Flywheels, DIY Projects
How do you remove driveshaft to replace clutch?
The driveshaft is removed to replace the clutch by unbolting the u-joints and retaining caps on each end of the drive shaft. The shaft can then be collapsed slightly to allow for easier removal. ...
Asked in Jeep Liberty Sport
How much would it cost to replace a bad universal joint on a 2003 Jeep Liberty?
Well, if it is a front driveshaft, the issue is a CV joint and you'll have to remove the driveshaft and take it in to be rebuilt. Taht will run you $150 or more. If it is a rear driveshaft, it will be cheaper if you remove the driveshaft and take it to a driveline shop where they can press in a new u-joint.....I'd recommend you replace both. A guess? $60 to $80 ...
Asked in Infiniti Q45
What does it cost to replace water pump on a 1992 Infinity q45?
it depends are u going to do the work ur self? buy the pump and take it to a pep boys or a midas they will do it cheapter than the dealer, your looking at 350 ...
How much to replace a water pump for 92 infiniti q45?
is included with timing belt service
How can you take out the play in your driveshaft on the rear end side of a 1997 ford ranger super cab 4.0 5 speed?
if the play is in driveshaft, replace u joints. if the play is actually in the diff, remove driveshaft and tighten pinion bearing. ...
Asked in Cars & Vehicles
Can you put a 1994 q45 transmission in a 1990 q45?
I have a 94' Q45 motor and transmission in my 1991 Q45 - so the answer is "probably". ...
Asked in Chevy Caprice Classic, Chevy Silverado
How do you disconnect the driveshaft from the automatic transmission of a 1992 Chevy Caprice?
Take a lose the four bolts on the yoke located at the rer of the driveshaft size 11mm put in neutral and wiggle it out the tranny ...
Asked in CV Joints
How do you replace opel cv joints?
That depends which model it is. On older models CV-joints were moulded into the driveshaft. To be replaced they had to be removed using a press and then warmed to be able to replace them. On these models it is often better to replace the whole driveshaft. On newer models CV-joints are attached with clips and can be replaced more easily. ...
Asked in Infiniti Q45
Where is the power steering fluid reservoir on a 1995 infiniti q45?
where is the power steering reservoir on 1992 infinity q45t
Asked in GMC Jimmy
How do you change the U joints in a 98 jimmy?
Mark drive shaft and yoke to re-install in the same location to maintain factory balance Remove and discard small "U" bolts that hold driveshaft Pry driveshaft out of yoke Drop driveshaft Bring to auto parts/machine shop to have "U" joint pressed into driveshaft Replace "U" bolts Re-install driveshaft in same position as removed ...
Asked in Car Starting Problems, Infiniti Q45
Where is the starter located on a 1992 Infiniti q45?
The 1992 Infinity starter is located on the right hand side of the engine. You can follow the positive battery cable directly to the starter. ...
Asked in Chevrolet
How do you replace a universal joint on a 1991 Chevy pickup?
Mark drive shaft and yoke to be sure to install in the same position to maintain factory balance Remove and discard 2 small "u" bolts at rear end Pry driveshaft out of yoke Slide driveshaft off splines at transmission tail piece Bring driveshaft to an auto parts/machine shop to have new "U" joint pressed into driveshaft Replace "U" Bolts with new ones ...