answersLogoWhite
Auto Parts and Repairs
Chevy Suburban
Chevy Tahoe
Door Panels and Handles

How do you replace the exterior rear door handle on a 1999 Chrysler mini van?

474849

Top Answer
User Avatar
Wiki User
2004-11-20 09:56:03
2004-11-20 09:56:03

The question you ask is too involved for a proper answer. You need to go to a car parts store, and get a repair manual for your car. They cost about $16.00 Or, go to a Public Library.

1

Related Questions

User Avatar

how to replace a exterior front door handle on a 1999 toyota tacoma

User Avatar

No. the regular power locks unlock the lift gate, and you have to grab the exterior handle to unlatch and open.No. the regular power locks unlock the lift gate, and you have to grab the exterior handle to unlatch and open.

User Avatar

To replace an air conditioner belt on a 1999 Chrysler LHS, rote the the new belt through the pulleys within the engine of your Chrysler vehicle.

User Avatar

Here are directions for a camary. It is basically the same for the avalon.http://autorepair.about.com/library/weekly/aa092504b.htm

User Avatar

To remove the handle the inside door panel has to come off,with the window up.there is a small bolt insde and one at the end of the door by the handle take those two off and the linkage inside...yes you need small hands.

User Avatar

will chrysler lhs not run wen ac belt is broken

User Avatar

youll need to take the door panel off, then unscrew the handle assembly and replace with a new handle ( junkyard?). screw that in then replace door panel.

User Avatar

you have to replace them......they are not self resting.

User Avatar

Take it to the dealer, this is not an easy job. Take it to the dealer, this is not an easy job. I did replace the outside door handle on my 1999 suburban drivers door. It is not a easy job and was very frustrating. Remove the inside door panel. The door handle is held on by two screws. There are also two rods to deal with. one for the lock the other for opening the door. Do not get them mixed up. I was able to get the new handle in with the door lock only partially in the new handle. Then with the new handle screwed in I was able to push the lock all the way into place. Test and replace door panel.

User Avatar

Lift up on the handle. You should see plastic inserts that fit into two tiny holes. Remove the inserts and the handle should slide to the side.

User Avatar

just pops out using small flat head

User Avatar

A 1999 Chrysler does not have a cabin filter.

User Avatar

In a 1999 Chrysler Concorde service manual.

User Avatar

http://en.allexperts.com/q/Chrysler-Repair-807/1999-Chrysler-Concorde-w.htm

User Avatar

Remove interior door panel and arm rest.drill out rivet that hold handle on.Find another handle at the junk yard. I don't know of anyone that can fix little piece of plastic that breaks.

User Avatar

Open the door, and look at the door in the area that is above the latch. there is one bolt that looks out of place... remove it, and then pivot the handle out and away from the side the bolt was located (towards the front of vehicle if on left side, etc) then before pulling out, look at the old one, and take note of how the handle is attached, so that you can attach to the new one in the same mannor.

User Avatar

Where are the factory amplifiers located inside of a 1999 Chrysler concorde?

User Avatar

If it is like my 2000 Cirrus, I use the key to pop the cover off, then just remove and replace.

User Avatar

fuel pump is located in the fuel tank. Tank musgt be removed for access.

User Avatar

DCX, Daimler Chrysler. Chrysler was owned by Daimler Benz, Mercedes, in 1999.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.