Want this question answered?
All Toyota Camry's have struts in the front. This is also accompanied with strut mounts and bearings that are located between the mount & strut. I highly recommend replacing the mounts & strut bearings with the struts. My experience has shown that the mounts fail before the strut.
how do i replace the front strut on 1999 Saab 9-3
It could be your front strut mounts need to be replaced. The rubber inside the strut mounts, wears out. You will hear the noise when u drive over bumps and uneven surfaces. my 2004 grand am se1 4 door ,with the 3.4 v6 engine and automatic transmission, needs the front strut mounts replaced.
replace the mounts
The heater pipe is at the rear of the engine and the strut mounts are on each side of the engine compartment. These are not easy to repair and you need special tools and a front end alignment ' when you are through.
There is one on the front passenger side and a torque strut on the front. The torque strut acts like a motor mount.
I have a 1990 Chevy Lumina and when you hear clunking sounds when going over bumps or dips or if you have ever replaced your strut assembly you should replace the mounts. You can buy a quickstrut online for a lumina. Front is around $180 and rear is around $80. Hope that helps!
4 engine mounts. front right, front center, torch strut that supports the radiador, & transmission mount
no
there is a fatty that comes and does it
try to tighten all the bolts on the strut mounts and double check
YES. Otherwise your tires will wear out fast and uneven.