# Disconnect negative battery cable # Drain cooling system # Disconnect heater hoses from the core tubes at the firewall inside engine compartment plug core tubes # Open the glove box remove the glove box and liner by removing the retaining screws # Remove the core access plate retaining screws and remove the access plate # Working under the hood remove the two nuts attaching the heater assembly case to the dash panel # Remove the core through the glove box opening place some towels on the floor to catch any antifreeze that may come out of core
Mercury Topaz was created in 1983.
This is not easy. Get a manual on your car from DISCOUNTAUTOREPAIRMANUALS.COM
Drain the water from your 1983 Chevy Caprice Classic cooling system. Remove the heater core water supply hoses. Remove the heater core retaining bolts. Reverse the process to install the new heater core.
1983 doesnt have a crankshaft position sensor. you have an ignition module located on the side of the distributor.
Mercury Microware was created in 1983.
The dry weight of a 1983 model, 40hp Mercury outboard, is 156lbs.
I am not quite sure how to answer this question........Maybe you meant a 1983 model?... Ford changed to fuel injection in the late 1987 model's. Early 1987 was the last of the carb's. And this is port injection, and not throttle body.
Assuming you mean Mercury Cougar, a new 1983 Mercury Cougar sold for $9800.
Mercury Grand Marquis was created in 1983.
The dry weight for an 1983 model, 80 hp Mercury outboard, is listed as 265 lbs.
1906 - 1983
How do remove and replace the ignition switch of a 1983 Oldsmobile Regency?